No but a 150 should, and you cannot stick a 250 engine in the 125 frame without major welding etc sorry, i tried this too :)
For a 2002 Ford Escort ZX2 ( in North America ) ( that would be the 2.0 litre , Dual Over Head Cam Zetec four cylinder engine )
It could possibly be the Cylinder Head Temperature Sensor (CHTS) which monitors the temperature of the coolant/water circulating through the cylinder head, and tells the computer to increase or decrease the injector spray length. Warmer temperatures = shorter sprays of fuel from injectors, and vice versa. -Anthony C.
A cylindrical reactor consists of a cylinder and a head. The cylinder and the head have flanges and a gasket seal; the head is attached to the cylinder by a set of 8 three-quarter inch stainless steel bolts. There is a gasket between the two flanges and a Bourdon gauge attached to the cylindrical portion (not shown). The inside of the reactor is 18 inches in diameter.
Horsepower TV - 2006 At Home Engine Machining and Cylinder Head Porting was released on: USA: February 2013
It is used to replace valve seals on many automotive engines without removing the cylinder head from the block.
The cylinder head is located on top of the engine. The spark plugs thread into the cylinder head(s).....
DOHC stands for Dual Over Head Cam : That means that each cylinder head has 2 camshafts on the top of the engine cylinder head ( in the case of the Ford Escort ZX2 , there is one cylinder head on the four cylinder engine so it has 2 camshafts on top of the cylinder head )
The purpose of the cylinder head is Luke Cooper
Cylinder Head Torque
Gasket between engine block and cylinder head
The cylinder head, is the part of the engine that contains the valves/ports that control air/fuel in and out of the engine. They are mounted on the engine block, over the cylinder/pistons. DOHC and SOHC have the camshaft/s mounted on them.
The cylinder head, is the part of the engine that contains the valves/ports that control air/fuel in and out of the engine. They are mounted on the engine block, over the cylinder/pistons. DOHC and SOHC have the camshaft/s mounted on them.
Usually the cylinder head holds the spark plugs.
Check on the driverside cylinder head. My engine code is on the head.
torque for 2c engine cylinder head bolts
Type your answer here... They are in the cylinder head.
It is the passenger side cylinder on the front head.It is the passenger side cylinder on the front head.