You can use a power bar to ground yourself if it's plugged in. Since the ground wiring normally bypasses the on/off switch, it doesn't have to be turned on either.
Additonally, if you are working on a computer that has an on/off switch on the power supply, you can keep the computer case grounded by leaving the power supply plugged in with the switch off. This offers an additional layer of protection from electrostatic discharge.
3000 volts From ESD Association ESD Handbook ESD TR20.20 section 5.3.2.1: "When people are charged with static electricity, they can release stored energy to conductive objects such as doorknobs and electronic circuits. This transfer of energy is called an electrostatic discharge. Sometimes the electrostatic discharge causes visible sparks, but more often, it is both unseen and unfelt. Electrostatic discharges can damage ESD sensitive components used in modern electronics. Static electricity is a natural phenomenon that occurs in all climates and at all levels of relative humidity year round. Most people cannot feel an electrostatic discharge unless the static voltage is greater than 2000 volts. However, some electronic circuitry can be damaged by ESD that is less than 2000 volts. The damage can be done without people having any sensation of the ESD event. When a wrist strap is worn properly and connected to ground, the person wearing it will stay near ground potential."
A: When there is work to be done on sensitive assemblies or there is known hi voltage differential from a person to the circuits
You wrap the strap around whatever you are taking off, then thread it into the wrench so it will tighten as you push.
resistors
the wrist strap will prevent computer components from being damaged by static electricity.
The safest way is to use an electrostatic wrist strap that you clip on to a ground. Another method is to touch the metal casing of the power supply on the computer. Its best to be on a tile or wood surface rather than carpet when you are working on your computer at home. Being on carpet can generate static electricity that will damage your computer.
grounding strap
Is there a bolt on engine ground strap
In a vehicle, it is the electrical strap that connects the engine to the rest of the car. The purpose is to make sure all electrical devices have a good electrical connection and to prevent static in the radio. In appliances it is a wire that connect the appliance to a permanent grounding device. The purpose is to prevent injury to the people who might touch the appliance. In a vehicle an earth ground strap is also a strap that drains static electricity off the car to the ground. They prevent painful static shocks when exiting the vehicle and eliminate electrostatic discharge ESD responsible for fire at gas stations.
The ground strap is the battery cable that connects from the negative battery post to ground, usually the chassis.
A wrist grounding strap is used to prevent electrostatic discharge when handling computer components. Just like a shock when walking on carpet can carry several thousand volts, it destroys computer components. In more detail, it is a wire leading from a technician's body (a wrist band with metal contact to the skin) to earth ground, with a high (1 megohm) resistance in it. This slowly discharges any static electricity that is built up on the body, to avoid discharging it into an electronic component. An electrostatic discharge (ESD) mat with similar connection to ground is also used to keep the electronic components at earth ground potential.
The ground strap prevents static electricity causing a spark, which could cause a fire.
You do not want to wear a wrist strap or be grounded when working on monitors/TVs or power supplies. Even when turned off these devices still hold a charge due to the large capacitors in them.
To prevent electrostatic discharge to crucial components regarding the electrical circuit you are performing work on.
The homonym for "leather strap" is "rein." The homonym for "royal power" is "reign."
On the engine block.
PRESUMING you have already unplugged it and removed the cover, ground yourself by attaching a grounding strap to your wrist and the computer case to prevent static discharge