How did the Titanic split?

Answer 1

the titanic split in half because when it sank its rear end was lifted up in the air to 45 degrees at an angle and its design is not built to carry the load of that rear end and its tendency is to split...is a popular version, but There is no evidence for the 45º angle. The original testimony indicates perhaps 20º.

It was certainly due to the weight of the flooded hull, but probably aggravated by very poor rivets and a likely design flaw regarding the expansion joints. The ship broke at the joint, which was heavily modified on the Britannic and reworked on the Olympic.

Answer 2

The builders of the Titanic, Harland and Wolff, tried to make her unsinkable, and they didn't realize the fatal flaw in her design: the expansion joint, located between the bow and the stern. As she was going down, the water increased the weight to 30,000 tons and the Titanic couldn't bear that much, so the stern broke away and the ship sank.

After the ship hit the iceberg the cold water rushed into the ship and hit the hot boilers in the engine room. This caused an explosion which helped sink the ship and she broke in half.
As the Titanic sank, it went up into a 45 degree angle. This angle, along with the thousands of pounds of passengers huddled up on the end of the stern put extra weight on the ship. And, of course, the ship was not designed to deal with the pressure. Where the ship broke, there were several dining halls, which are large rooms. Those large rooms were just big open spaces, creating a natural weakpoint in the ship's architecture. So, as it sank, there was this weakpoint, and at the angle it was at, it broke.

Answer 3

The Titanic split in half because of the great pressere in the water. As the ship sank great pressures pulled a part of the ship into the water. The whole thing could't go in all at once it had to break if you see the positioning it had to break.

Answer 4

Because of all the pressure on the bow of the titanic from all of the that is already inside the ship which made titanic break from having too much pressure

Answer 5

The reason why the Titanic split into 2 was because the back half rose so high that it split in 2, because it was too much for the middle.

Answer 6

The titanic split because, the end of the ship rose to high so the middle couldn't hold it up any longer so it split right in the middle.

Answer 7

Because it hit an iceberg