first we connect the 3 volt meter in three loads then we measure the voltage and find the resistance of the loads then put the formula p=v/r
so in this method we get the power by using 3 volt meter ....(prashant)
Three phase voltage can be measure line to line (L1-L2, L2-L3, or L1-L3) with a quality digital voltmeter. In the United States, typical 3 phase voltage is 208-230VAC, or 460-480VAC measured line to line. Line to ground or neutral with a 208-230V system will yield 110-120VAC, which provides standard household power for things like televisions and microwave ovens.
An ideal voltmeter has infinite impedance(resistance). If you were to break the circuit and put it in series and try to make a measurement, it is easy to see that the circuit would act completely differently and your measurement would be wrong. An ideal ammeter is always connected in series because it has 0 resistance, so all of the current would flow through it, and not through the wire that you are trying to measure the current of.A better answer though is to think about what you are trying to measure. When you say something is 3 Volts, that is a difference between the voltages at two different points. If you want to see what the voltage drop across a resistor is, for example, you need to put one probe of the voltmeter on one side of the resistor and the other probe on the other side of the resistor. That setup is simply called being in parallel.Voltage is potential difference between two points, hence measured across or in parallel, where as current is measured in series since current flows (*)
The voltmeter would read 12 volts. An ammeter connected to to battery would only read 4 amps (12 volts divided by 3 ohms =4)
3x3x3x3x3x= your answer
It is: 2*3*3*3*7*7 = 2646
What is the definition of voltmeter-ammeter method?
active power,reactive power and apparent power
A voltmeter is an instrument used to measure electric potential difference. The voltmeter have two electrodes, reference electrode and test electrode, the electrodes are put in two different places where you want to find the potential difference. For instance, if the test electrode is placed on the positive pole and the reference electrode on the negative pole of a 3V battery, the voltmeter would read '+3 volts'.
Using the eureka can or the water displacement method.
3%
I am assuming that you really want to use ammeters to measure power in a balanced 3 phase system. (hope you are not meaning 3 watt meter method) Power in Watt in a three phase system is equal to 1.73 x line voltage x line current x power factor. You need to know line voltage, power factor also in addition to current to compute the power. If the system is balanced then actually you do not need to connect ammeters in all three lines. One ammeter reading will do.
It's cheaper.
Cubic units are used to measure 3-Dimensional objects. The cubic(x to the third power) units are used to demonstrate the 3 dimensions.
This is too complicated to describe on this forum, but there are lots of web pages that describe the 'three-ammeter' method of measuring power, so your best plan is to visit one of those sites.
Fill the 6 gallon cylinder half full. Solution Method 3 gallons / 6 gallons = 1/2 full
You will need a digital voltmeter. Set the voltmeter to 20 volts DC. Check it with the probes. 1. 12.68 Volts = 100% Charge 2. 12.45 Volts = 75% 3. 12.24 Volts = 50% 4. 12.06 Volts = 25% 5. 11.89 Volts = 0%
deductive method inductive method