If you mean on a car it is simple, I think you are looking for more HP's. If this is the case buy a larger one unclamp the old one and plug it in to your wiring harness where you unlpuged the old one. Go to Summit Racing.com and check them out. I hope this helped.
Yes and my proof is I have one
A UPFC is a type of power controller that has shown to be more efficient in the control of power flow than a SSSC. A STATCOM can be used to inject power flow into the controller whether it be a UPFC or a SSSC.
The motto of IONICS Mass Spectrometry Group is 'Go With the Flow
Driver IC is device which controls the flow of current through other circuit or other components.
If your ps3 controller isn't working wirelessly, then you may have to reregister it. To do this, you have to plug it into the ps3 with the special cord. If it still doesn't work, even if it is left plugged in, then you may have something wrong with your controller and you may have to purchase a new controller. You should also check the charge on the PS3 wireless controller. if you unplug a PS3 that battery is not charged it will not work. When you turn off the PS3 if you have not set the PS3 to also turn off the controller automatically in controller setting the controller will remain on and the battery will drain. The PS3 does not charge controllers when it is off.
A mass flow controller is used to measure and control the flow of liquids and gases. It keeps the fluid or gas flowing consistently at the perfect rate of speed.
How do i replace mass air flow sensor 1992 lexus es 300
How to locate and clean or replace mass air flow in Mercedes ml320
how do I replace a mass air flow sensor on a Hyundai Accent?
you will almost always have to replace them.
Replace part, clear code and you are done!
You can't. You either replace it or get it rebuilt.
Replace the mass air flow meter(s) (MAF).
clean or replace your mass air flow sensor
your mass air flow senser has low frequency (replace it)
your mass air flow sensor is located at the top of your air filter where it connects to the engine. to replace it you remove the two screws unplug the sensor and pull it out and just reconnect the new one in.
No controller in port mean your controller is either defective, or broken. You will require to replace the device in order to solve this problem.