it seems you cant , seald unit
its located directy underneath the battery box. (its the thing with the cooling fins on it) you just unplug it and pull 2 bolts out that are holding it in
According to the Continenal Battery website it is a 12V battery.
noob
AS YOUR SITTING ON THE MOTORCYCLE, IT IS BEHIND THE R.H. SIDE COVER
how to replace front shock absorber on Mitsubishi 1997 TE Sedan
Hutton Magna, County Durham. Appleby Magna, Leicestershire. Canford Magna, Dorset. Chew Magna, Somerset. Sheepy Magna, Leicestershire (I kid you not). Fontmell Magna, Dorset. There are probably more.
On the left side of the battery,on the side of the starter solenoid,behind the clip down cover. 30Amp.
The Magna Carta document
To replace the headlight bulb in a Mitsubishi Magna, start by opening the hood and locating the back of the headlight assembly. Disconnect the electrical connector by gently pulling it off. Remove the bulb by twisting it counterclockwise and then replace it with a new bulb, ensuring it's securely in place. Finally, reconnect the electrical connector and test the new bulb to ensure it works properly.
Two possibles. Either the battery needs to be replaced, or the stator is not charging. First check the battery with the engine off, should have 12. 2 volts or more, if under 12 volts, then charge and check again. If under 12 volts, then replace. If over 12 volts, run engine, check the battery volts, should have over 13 volts at idle, rev up, should get over 14 volts. If battery still shows only 12. 2 or so volts, then the stator in the engine has to be replaced.
The address of the Magna Library is: 8339 West 3500 South, Magna, 84044 1853
To replace the front indicator on a Mitsubishi Magna, first, ensure the vehicle is turned off and the keys are removed. Remove the screws or clips securing the indicator assembly, then gently pull the assembly out of the housing. Disconnect the wiring harness from the old indicator bulb, replace it with a new bulb, and reattach the wiring. Finally, reinsert the assembly back into the housing and secure it with the screws or clips.