The chimney at Kilroot Power Station in Northern Ireland stands at approximately 200 meters (656 feet) tall. It is one of the tallest structures in the area and plays a significant role in the power generation process at the facility. The height of the chimney helps disperse emissions more effectively into the atmosphere.
300 ft.
300 ft.
Primarily lightning protection, but with weather stations at several levels
Santa Claus is 4 feet 3 inches. Santa just looks taller because he is surrounded by elves, giving the impression of massive height. Santa cannot be tall due to all the stooping and chimney falling he does. It would not be physically plausible if he was tall, his back and knees would give out, and without medical, Santa could be disabled.
Any chimney should terminate at least 600mm above the ridge height. This is a minimum to comply with building regs. This is measured to the top of the pot. If the terminal is coming out of the "slope" of the roof and not the ridge, then at least 2.3m measured horizontally from the roof surface. These are to meet the minimum requrement of building control but in reality can differ with each installation. Things like neighbouring buildings, tall trees and locallity can all affect the working of the chimney, as can the internal size of the flueway and where it is located on the house itself. If the chimney is internally built, there is good insulation from the building itself to keep the flue gasses warm. If the chimney is on a gable end with only 4" of brickwork between it and the outside, then the movement of the flue gases will be slower due to them cooilng down. I would like to say that you should be confident in the advice given by getting a tradesperson that has the relevant certificates to do the job in question. but you would be better contacting the governing body in question (HETAS or GASafe for example) and getting the list of recommended installers.
300 ft.
300 ft.
An industrial chimney is a tall chimney, usually built of clay kilned brick during the Industrial Revolution, that is there to lift any smoke and pollution high into the air. The tall height also created a good air flow.
The tallest smokestack or "chimney" in the world is 1,378 feet tall or 420 meters. It is in Ekibastusz, Kazakhstan. The GRES-2 power station.
so that the smoke which comes out of the chimney is kept away from choking in the nearby area. pd
The height of a two-story chimney typically ranges from 20 to 30 feet, depending on the height of each story and the design of the chimney. A standard story is usually about 10 to 15 feet tall, so a two-story chimney would be constructed to accommodate this height. Additionally, factors such as the chimney's location, building codes, and architectural style can influence its final height.
catching midgets chimney sweep
The chimney in the Bates Mill Complex in Lewiston, Maine, stands approximately 150 feet tall. It is a prominent feature of the historic mill complex, which played a significant role in the region's industrial history. The chimney is a notable landmark and is often recognized for its architectural significance.
The chimneys or smoke stacks from factories and mills were made very tall to keep the smoke from choking everyone in the nearby area. With a taller chimney the smoke would usually dissipate before it hit the ground.
No. It just has to be circular in section with some height/length; a wedding band is a cylinder as is a factory chimney or a drainpipe.
A pylon power cable, often referred to as overhead power lines, transmits electricity from power generation stations to substations and ultimately to consumers. These cables are suspended from tall structures known as pylons or towers, which help maintain the necessary height and clearance for safety. They are designed to handle high voltages and are essential for the efficient distribution of electrical power over long distances.
The subject includes the whole of the noun-phrase that acts as the subject, not just the head word.The tall, red, brick chimney dominated the skyline.