answersLogoWhite

0

The timing is set by aligning the timing marks on the camshaft pulleys with the crankshaft pulley. The easiest way is to use the markings on the timing belt. Then turn the engine by hand through 2 revolutions to make sure the timing marks line up.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Where can you find the timing reset button on a 1990 Lexus LS 400?

I have a 1990 LS400 and I have never heard of a timing reset button. The timing is set by the timing belt and controlled by the computer. Let me know if you find out there is such a thing. vbd


Where is fuel pump reset button on Lexus Ls400?

It does not have one.


How do you reset the tail lamp indicator on a 1998 Lexus LS400?

There is no reset for taillamp failure relay. If there is a fault the message will continue to be displayed www.lextechautomotivellc.com


How do you reset the computer on a 1992 Lexus ls400?

To reset the computer on a 1992 Lexus LS400, disconnect the negative battery terminal and leave it disconnected for about 10-15 minutes. This will allow the onboard computer to clear any stored trouble codes and reset the system. After waiting, reconnect the negative terminal, and start the vehicle to allow the computer to recalibrate. Make sure to check for any persistent issues that may have caused the need for a reset.


Where is the fuel pump reset button located on a 1993 Lexus LS400?

The fuel pump reset button on a 1993 Lexus LS400 is typically located in the trunk, near the right rear side. You may need to remove a panel or cover to access it. The button is a small red or black switch that can be pressed to reset the fuel pump after an accident or a fuel-related issue. Always refer to the owner's manual for specific details and instructions.


How do you find the reset code for a replacement radio for a 1990 ls400?

Go to a dealer


How do I reset Ls400 check airbag light?

To reset the airbag light on a Lexus LS400, first, ensure that the vehicle's ignition is turned off. Then, locate the diagnostic connector, usually found under the dashboard, and use a jumper wire to connect terminals TE1 and E1. Turn the ignition on without starting the engine; the airbag light will blink to indicate the reset is in progress. After a few seconds, remove the jumper wire, turn off the ignition, and then start the vehicle to check if the light has reset. If the light remains on, there may be an underlying issue that needs professional diagnosis.


How do you change Lexus ls400 idle control?

To change the idle control on a Lexus LS400, first locate the idle air control valve (IACV), typically found near the throttle body. Disconnect the electrical connector and remove the mounting screws securing the IACV. Replace it with a new valve, ensuring a proper seal, and reconnect the electrical connector. Finally, reset the engine's idle by allowing it to reach operating temperature and checking for any error codes.


How do you reset timing belt?

Timing belts are replaced, not reset.


How do you reset oil maintenance on 2010 Lexus gx 460?

How to reset oil maintanance on a lexus gx 460


How do you Reset dashboard warning lights on 90 Lexus ES250?

How do I Reset dashboard warning lights on 90 Lexus ES250


How do you reset injector maintenance indicator on Lexus ls460?

PLIZ HELP How can i reset the injector maintenance required in lexus gs350 2012