0
What else can I help you with?
Difference between line driver and push pull circuit?
Line Driver A line driver is a sourcing output. When in the on state, a line driver will supply Vcc. In the off state, a line driver will float. Because of this, a sinking input is required for proper operation. Open Collector An open collector is a sinking output. In the off state, an open collector will supply a path to ground. When in the on state, an open collector will float. For proper operation, a sourcing input is required. Push-Pull A push-pull output is a combination of a line driver and an open collector. In the off state it will supply a path to ground and in the on state it will supply Vcc.
What are the ratings and certificates for Two and a Half Men - 2003 Grab a Feather and Get in Line 10-13?
Two and a Half Men - 2003 Grab a Feather and Get in Line 10-13 is rated/received certificates of: Netherlands:AL
What is a half back used for in football?
The half back is actually misleading. As aligned from the ball at the line of scrimmage, the half back, sometimes called a tailback is furthest from the ball and is the primary ball carrier.
Why did France fall quickly in 1940?
They concentrated most of there military on a long strip of land called the maginot line. The Germans first made a diversion on the upper half of the maginot line to draw the french away from the bottom half. Then they attacked the bottom using blitzkrieg and cut off multiple sections of the maginot line. Other than that, the french had no other defense against the germans.
What were some weakness of the French Maginot line?
The Ardennes Forest (the s is silent) the ONLY open space in the Maginot Line where the French did not think Hitler would cut a path to France by marching through the forest.
What is the line on a symmetry?
the half of a person place or thing
Can you open the compass in full length of a line in the replace of just over half of the line?
I don't understand your question ...
What is a line that cuts a circle or a sphere in half called?
a bisecting line ? Diameter ______________ The question needs to be re-thought. Lines do not cut spheres in half, no matter where the line is in the sphere. The simplest thing that can cut a sphere in half would be a plane.
What is the middle thing when you fold the paper in half?
When you fold a paper in half, the line that runs down the center is called the crease.
Why does Half of the electrical box works other half doesn't?
One side of main breaker is broke. One line to the house is open.
What is a line that cuts a segment in half?
A line that cuts a segment in half is a bisector
What is a bisecting line?
To bisect is to cut or divide into halves. A bisecting line would then be a line that divides another line in half or a line that divides an angle in half.
How far is it from the half court line to the end line on a high school court?
The half court line is 55 feet from the end line
What is an open half line?
A line which has one end, but stretches off to infinity is called a ray. If we want to show an interval such as [2,infinity) which means all the numbers between two an infinity including two, we put a close dot at two and draw a ray going to the right. Similarly for (negative infinity, 2] we draw the closed dot at 2 but this time the ray goes to the left. Now if we draw an open circle, or a the out line of a dot this mean the interval (2,infinity) where we are considering all the numbers very close to two but not two itself This is an open half line and it represents an open interval.
What does half a blue line mean on the QuickVue pegnancy test?
no your not pregnant if you have a half blue line
What divides angles and line segments in half?
An angle is divided in half by the angle bisector. A line segment is divided in half by a midpoint.
Is half open plane connected?
A half-open plane, typically represented as (\mathbb{R}^2) with one side excluded (like ( \mathbb{R}^2 \setminus {(x, y) : y < 0} )), is connected. This is because any two points in the half-open plane can be joined by a continuous path that does not cross the excluded region. However, if the plane is divided into distinct regions, such as removing a line or a point, it may become disconnected. Overall, the specific structure of the excluded area determines the connectedness of the half-open plane.
