answersLogoWhite

0

I'm not an expert on I.J.'s, I'm here looking for answers myself, but to my knowledge, older doubles and o/u's didn't have ejectors unless it was a reputable name brand and would be a more expencive model. I can't prove it true, but this what I was told by a few local old timers, they have more experience then me, I don't have much choice too believe it until found wrong.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you know if extractor is bad in Ithaca m66 shotgun?

To determine if the extractor in an Ithaca M66 shotgun is bad, check for consistent failure to eject spent shells or frequent stovepiping. Inspect the extractor for visible wear, cracks, or deformation, which can affect its grip on the shell. Additionally, test the extractor's tension by manually cycling the action and observing if it securely holds a shell in place. If these issues persist despite cleaning and lubrication, the extractor may need replacement.


How can Distinctive markings of shells and cartridges be made?

firing pin , breech block, and extractor and ejector mechanism


Where can you buy auto start car start replacement remote?

http://www.lockdownsecuritycanada.ca/Autostart-Remote-Replacement-Shells-s/560.htm


How do you change from high power to low power shells?

To switch from high power to low power shells, you need to manually unload the high power shells from your firearm and load the low power shells instead. Make sure you select the appropriate shells that are suitable for your firearm and intended use to ensure safe and effective shooting.


Why will my 20 ga auto Charles daly not eject the spent shells It is brand new?

the extractor might be missing or broken The best thing you can do is take your gun to a qualified gunsmith.


What part of the gun ejects gun shells?

There is a part almost all guns called the extractor that, like its name implies, extracts the shell when the bolt of the gun recoils back.


Does a Stevens Crackshot model 16 have an extractor or do you have to manually extract the spent cartridge?

Stevens Crackshot #16 sidelever does indeed have a crecsent shaped ejector that fits in the recess in the bottom of the chamber.It is operated when the lever is worked although I don't think they were a very good system and you probably end up levering as many spent shells out with a pocketknife as it ejects properly. NOTE: The Stevens # 16 has an extractor,which partially removes the spent shell from the chamber,rather than an ejector, which completely expells the spent shell from the chamber. Does anyone know a good source for these extractors??? HG


Why does your model 58 not eject shells?

Almost impossible to say without having the gun in hand. The two most likely reasons are that parts are dirty, or parts are worn/broken. I would start with a thorough cleaning, with special attention to the chamber, bolt, and extractor/ejector. If that does not cure the problem. look for wear or breakage of the extractor/ejector.


Will your Stevens 87b shoot long rifle shells?

Yes it will as well as 22 short and long rifle, but the rifle will only shoot the 22 LR shells as a Semi auto and the shorts and longs you will have to manually cycle the gun by hand


Where can you get a clip for 3 inch shells for a 20 gauge Ranger 101.2 shotgun?

We carry new replacement magazines for that shotgun.


Can 3 inch shells be used in the marlin model g 60 410 gauge?

slide a 3" shell in the chamber manually and see if it fits without being forced.


Investigation into pozzolanic properties of palm karnel shell ash as a parcial replacement of cement?

palm karnel shells price in nigerian market.