answersLogoWhite

0

Hello there!

Did you not receive a set of instructions with your game?

I have this game and received a set of instructions- I also have the "Fingers On Buzzers" game.

If not. Here you go.

Basically, make sure everthing is plugged in.

Ensure the buzzer stand is on a flat unit.

Put your DVD Player remote about 5 cm away from the red light panel on the front of the stand.

Press and hold the white "Set button" on the stand.

The UP LED light will light up you must press the up button on your DVD remote.

When the LED Light has blinked, you must press the UP button again.

Repeat this procedure for right, down and left.

When all four LEDs are lit press eht enter button, and then as before a second time.

When all four LEDs go off- you are finished!

Hope this helps.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you build a remote door buzzer?

use a walwort, switch, and solenoid.


Advantages and Disadvantages of implementing a remote working system?

Answer--The advantages and disadvantages of implementing a remote working system within a company. The advantages and disadvantages of implementing a remote working system within a company.The advantages and disadvantages of implementing a remote working system within a company.


What are the advantages and disadvantages of remote working system?

i need to know that "What r the advantages and disadvantages of remote working system " i need to know that "What r the advantages and disadvantages of remote working system "


Why is my Liftmaster remote not working?

Your Liftmaster remote may not be working due to a dead battery, signal interference, or a malfunction in the remote itself. Try replacing the battery, reprogramming the remote, or contacting Liftmaster for further assistance.


Why is my garage remote not working?

Your garage remote may not be working due to a dead battery, interference from other devices, a malfunction in the remote itself, or a problem with the garage door opener.


Where can I find codes for RCA remote?

you can find it at any shop wherever you buy the remote. if there's no codes working for your remote maybe you should buy a new one that can get the codes working in it.


Remote car starter stopped working after a new battery was installed How do you get it to work again?

If the remote car starter stopped working after a new battery was installed in the remote, the remote needs to be reprogrammed. If the remote starter stopped working after a new battery was installed in the vehicle, the computer might need to be reset by disconnecting the battery for a few minutes.


Why is my remote control not working for Toyota Sienna alarm system?

The remote might be out of batteries so it is not working. You could also be too far away or the sensor might not be working.


Why is my garage door remote not working?

Your garage door remote may not be working due to a dead battery, interference from other devices, a malfunctioning remote, or a problem with the garage door opener itself.


Why is my remote control ceiling fan light not working?

Your remote control ceiling fan light may not be working due to issues such as dead batteries in the remote, a faulty remote control, a problem with the fan's receiver, or a blown light bulb.


TV remote working principle?

buhaha


Why would my 2005 Malibu key less remote stopped working?

Replace the battery in the remote