answersLogoWhite

0

There is little to no difference.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Why 3 phase and single phase?

3 Phase system is for industrial use and 1 phase is for house hold application


Do televisions use single-phase or 3-phase power?

Answer 1: TV's use single-phase power. Answer 2: TV's use single phase power of 220 or 110 volts ac power depending on what part of the world you live in.


If you use Polymerization in your battle phase will the battle phase end?

Polymerization is a spell speed 1 card. You cannot activate it in your battle phase at all.


What is the First jutsu sakura used in the Japanese anime?

Shadow clone jutsu was the first we saw her use on episode 1


How do I check to make sure a three phase transformer is still in working condition?

Using a properly rated voltmeter and following all safety precautions, check from phase to phase on each phase on the secondary side. phase 1-2 then 2-3 then 1-3 and they should all be within a few volts of each other.


If 1 phase 240 is used to power a piece of equipment that should be powered by 3 phase 240 will it damage the equipment?

odds are it is a motor and that would be yes


How do you know if a three phase motor's winding is shorted?

You use a megger. This allows you to check what the condition of the insulation of the motor windings are. An ohms check on each phase should be an easy way if it reads OPEN then there's your bad phase. Otherwise there are diffrent types of 3 phase motors, could be the brushes, commutator, sliprings, many many things.


What are the release dates for Spicy City - 1997 Tears of a Clone 1-3?

Spicy City - 1997 Tears of a Clone 1-3 was released on: USA: 1 August 1997


Is Shadow a clone in Sonic X?

no shadow is not a clone because 1.skadow is black 2.his spikes are up not down


Is there an S phase after meiosis 1?

No, there is no S phase after meiosis 1.


What are the release dates for The Chronicle - 2001 Tears of a Clone 1-14?

The Chronicle - 2001 Tears of a Clone 1-14 was released on: USA: 25 January 2002


Why is power generated only on 1 or 3-phase not any other?

Most electricity for the power grid is generated as 3-phase because this can be most economically sent long distances on high voltage power transmission lines. While the additional wire and equipment is more expensive than 1-phase, resistive losses are minimized by using high voltage and radiative losses are minimized because the different phases partially cancel each other. Most power transmission lines use 3-phase-delta as it requires no separate return/neutral line (as required by 3-phase-wye, 2-phase, and 1-phase) thus saving some money on these very long lines. Using more than 3 phases would be uneconomical as the costs for additional wire, insulators, poles in switches, transformers, and other equipment would increase without any additional savings beyond the use of 3-phase. By use of transformers the electricity generated, transmitted, and distributed as 3-phase can be converted to whatever must be delivered to the customer according to their needs: 3-phase-delta, 3-phase-wye, 2-phase, or 1-phase. Most industries have 3-phase delivered as either delta or wye because large motors start and run easier and more efficiently on 3-phase than on 2-phase or 1-phase. Also if the industry needs DC, 3-phase is easier to rectify (using a 3-phase bridge rectifier) and filter to get DC with less ripple than using 2-phase or 1-phase. Most homes have 2-phase delivered and use both phases for appliances, and one or the other phase for devices needing only 1-phase power. Most small generators/alternators generate only 1-phase to keep them simpler and less expensive.