Buy an unrestricted CDI unit. I would suggest Daytona. Be sure to check how many pin's you have, so you know that it is going to fit.
The symbol for electronic fuse can be obtain by marking a line on paper after that remove some portion of line from middle and make a horizontal s with length of below 1CM it is the basic symbol of electronic fuse you will also found on the books.
You will need to remove the dashboard panel in order to replace the electronic throttle control light. With the dashboard panel removed the light can be access to be replaced.
There are many advantages of an electronic toothbrush. They are able to get into places where a regular toothbrush can't. They remove more plaque than a regular toothbrush and the pulse effect, also replicates the tools which are used at the dentist.
Use a pencil eraser to clean off the contacts and remove the corossion. You can also use CRC electronic cleaner to clean out all the acid residue.
It's most likely programmed within one of the vehicles computers and not something physical that can be removed. Re-programming the computer may be the only method of defeating this safety device.
Do you mean the REV Limiter? It is in the computer. Can't remove that!
replace the stock CDI with a performance (orange or blue) CDI, make sure you get the right one, some are AC and some are DC.
It is not recommended by the manufacturer to remove the speed limiter on a Fiat Doblo. The speed limiter is installed for the safety of the vehicle operator.
The battery is inside the floor pan on the right side. Undo the single screw and then slide out the battery.
swap the transmission with one that has gearing allowing you to go that high, turbocharge it, and drive downhill. Also, remove the electronic limiter in the ECU programming.
The rev limiter is part of the engine computer programming. The computer would need reprogrammed to change the rev limiter.
It is controlled by the ECU, which you cannot remove.
You can't.
Replace your CDI
Why. Not fast enough ?
the limiter plug is in the end of the magazine tube.just loosen end nut cap,remove barrel,pull off slide,then point towards ground,limiter plug should fall out;then reassemble without limiter!if you have problems read your manual or read online manual at stoeger.com !
Not at all, is it not illegal to reprogram or even remove a rev limiter, however it may affect your warranty etc.