0
What else can I help you with?
What is the difference between through-hull transducer and transom mount transducer?
A thru-hull transducer is mounting through the hull of the boat. So you would actually take the boat out of the water, drill a hole in the boat approx 2" in diameter(depends on transducer model) and mount the transducer "thru-hull." -- A transom-mount transducer is a transducer bolted to the transom of a boat. Both kinds of transducers need to be submerged in the water for them to work correctly. www.sailboattalk.com I dont know a whole lot about this but I do know you dont drill a hole thru the hull. I have a ranger and from the factory mine was placed inside of the hull under my battery storage no hole needed to be drilled. But on a transom mount you have to drill holes into the transom.
What are the release dates for Mount Piney - 1968?
Mount Piney - 1968 was released on: USA: December 1968
What are the release dates for Mount Hood - 1918?
Mount Hood - 1918 was released on: USA: 23 February 1918
What are the release dates for The Ascent of Mount Blanc - 1903?
The Ascent of Mount Blanc - 1903 was released on: USA: 17 January 1903
What are the release dates for Guard Mount Ft- Myer - 1897?
Guard Mount Ft- Myer - 1897 was released on: USA: February 1897
What is climbing on to a horse called?
When you go to ride a horse and you get on its called mounting to get of you are dismounting.
What is the term used to get off or alight from a horse?
To dismount, I believe. As opposed to mount (to get on a horse).
What is the motto of Mount Dora Police Department?
The motto of Mount Dora Police Department is 'First in the Nation'.
What tools do I need in order to mount my LCD monitor to a wall using this?
In order to install an LCD mount you should ideally have a drill, with a drill bits and driver bits, a level and a stud finder.
How can I mount a Ring doorbell on a brick wall?
To mount a Ring doorbell on a brick wall, you will need a masonry drill bit, anchors, and screws. First, mark the drill holes on the wall where you want to mount the doorbell. Then, drill holes into the brick using the masonry drill bit. Insert anchors into the holes and screw in the mounting bracket for the doorbell. Finally, attach the Ring doorbell to the bracket and secure it in place.
What is diamond point bits used that mount in Dremel for?
These are to drill in glass
What tools do I need to install a TV mount?
Crew driver and a drill.
What are aircraft length drill bits?
These are usually 6 inches long, and have a 1/4" thick part at the base to mount in the drill.
How do I put up a TV mount?
To put up a TV mount, first locate the studs in the wall using a stud finder. Mark the stud locations and drill pilot holes. Attach the mount to the wall using screws and a drill. Make sure the mount is securely attached before hanging the TV on it.
How do to remove a stripped motor mount bolt on a SSEI Bonneville?
Well your gonna have to have a new mount bolt. Drill it out so that the drill bit is the same size as the hole the bolt goes into. Snap the head off when you drill past thehead. The bolt should hand screw out. If not use vicegrips. Then put the new one in the same place. Should replace the mount aswell.
What tools will be needed to mount this?
Just a screwdriver and possibly a drill and stud finder to get started.
Differentiation of mounting and dismounting?
Mounting refers to the process of climbing onto or getting on top of something, such as a vehicle or a horse. Dismounting is the process of getting off or stepping down from something, usually after having been mounted onto it. Both actions are essential for safely and effectively interacting with objects that require physical access.
