Fuse's are used to limit electrical current to a "safe" level within an electrical appliance. Since the fuse has blown it indicates that something as happened within the television which is causing it to draw an excessive amount of electrical current. The most likely cause is that a component has failed in a "shorted" state. Identifying the specific component will require some experience in electronic troubleshooting.
The device that the fuse is protecting is causing the fuse to blow. It could be in the conductors that feed the device. Disconnect the device and see if the fuse blows. If it doesn't, then the wiring to the device is good. If the device is a motor load it could be seized bearing that cause the problem. With the rotor stalled the current will go high and blow the fuse. If you know an electrician, see if the device can be meggered to see if the internal wiring has gone to ground and is short circuiting as this will also cause a fuse to blow.
Mine blew too, i dont know why, i tuched some wires with my 02 sensor, basicaly exposed wires will cause ur ecu fuse to blow, i dont know why tho, i have the same problem Mine blew too, i dont know why, i tuched some wires with my 02 sensor, basicaly exposed wires will cause ur ecu fuse to blow, i dont know why tho, i have the same problem
This is the starter fuse I am talking about. It doesn't blow every time. It might go weeks before it blows again.
sounds like a short circuit in trailer plug or wires to it?
No, you should not use a higher amp fuse for a lower amp machine. Fuses are designed to protect electrical circuits by breaking the connection when the current exceeds a specific limit. Using a higher amp fuse can lead to overheating and potentially damage the machine or cause fire hazards, as the fuse may not blow in a fault condition. Always use the fuse rating specified by the manufacturer to ensure safety and proper operation.
What would cause your fuse to blow when you turn on your lights on your 1993 mazda 323 the fuse to the tail lights on dash lights blow?
i just changed my fuel pump and it has not blown the fuse so i would say that it can cause the fuse to blow
An Electrical Short Cut somewhere would cause it to blow the fuse. A pinch wire would ground the system, and cause a shortcut.
Not necessarily. It can blow because the circuit was overloaded and pulling too much current. That would cause the fuse to overheat and blow.
the relay switch maybe stickin
Yes if you have too heavy a fuse in, it won't blow the fuse and can burn out the light or wiring,always use the properly rated fuse
A short somewhere could do it.
Usually if a seat motor is causing the fuse to blow then the motor is going bad. It could be using more amperage than it is designed to use. This will cause the fuse to blow. DO NOT be tempted to put in a bigger fuse. This can cause a fire. Good luck.
A fuse blows when the circuit is drawing too much current. It could be a short or an overload.
A bad diode can cause the 10a fuse to blow. (it looks like a fuse that is located above and left of the AC fuse)
When you are presented your birthday cake, make a wish and blow out the candles. An electrical surge will often cause an overload and blow out a fuse.
There is probably a short in the wiring.