They mean 'beyond low', meaning the worst - "I know, it was beyond pants", she shouldn't have done it, it was so bad, it was so low.
Reaching new heights means that you have done something you have never done before. You have gone over and above what you previously did.
The rate at which work IS being done - or at which it would be done if you switched on an electrical appliance or some other piece of electrical equipment - is called 'power' and it is measured in watts.
A short-circuit test is done to determine the power lost in the resistance of the primary and secondary windings of the transformer. It is done at full load current but with only enough voltage to give the required current with the secondary short circuited. An open-circuit test is done at full load voltage but no current is taken from the secondary, and this enables the power lost in the magnetic core of the transformer to be measured. As well a power, the tests also allow the inductances to be measured as well as the resistances, in order ot characterise the transformer fully.
It's called saturation because the collector voltage cannot go any lower. You've done all you can do with your base current (in Common Emitter configuration) to lower the collector voltage and support the collector current.
Movement of a joint beyond the anatomical position is termed hyperextension. This occurs when a joint is extended beyond its normal range of motion, potentially leading to injury if done forcefully or repetitively. Hyperextension can be seen in joints like the knee or elbow when they are pushed past their straightened position.
An extension past the anatomical position refers to moving a joint beyond its neutral or straight position. For example, hyperextending the knee means straightening the leg beyond the normal straight position. This movement can be done intentionally or unintentionally and may result in injury if taken too far.
This is a question designed to see if you have done your research to see what the current pay scale is -- you answer truthfully.
This is a question designed to see if you have done your research to see what the current pay scale is -- you answer truthfully.
The gravitational potential energy of an object depends on its mass, the acceleration due to gravity, and its height above a reference point. This energy is a measure of the work done in lifting an object against gravity to its current position.
It isn't. It is only kept at maximum resistance when the motor is not running. That is done to limit the starting current.
Saving time and being efficient can save a company or business money. Be prepared to give real-life examples of what you have done in your current or former employment when answering this question.
Robots.
A bang-up job is a really well done job; a job which has impressed you as being above and beyond the normal one.A "bang up job" is a great job.
To drag and drop is a way of moving something with the mouse. You are effectively dragging it from its current position and moving it and then dropping it into its new position. It is done visually, so you can see it happening, unlike when you do the same thing using Cut and Paste commands.
Go to the higher floors and push them through the holes and they should fall into the right position Once you've done it once you won't have to do it again.
Yes, the scissor hop is done from the traveling lunge position.