0
Oscillator that uses two passive elements for the timing. Namely resistor and capacitor.
It's an oscillator whose frequency-determining "tank" does not contain an inductive element, like a coil. These are good for extremely low frequencies--down to a few Hertz--but LC oscillators are better at radio frequencies.
An Rc oscillator is an oscillator that uses 3 or more phase shift networks, ( a network of a capacitor and resistor) as a frequency determining network (tank circuit) and a transistor to amplify that output, that only allows a certain frequency through by only letting the frequency that is able to shift 180 degrees out of phase through. And also has a feedback network from the collector (of the transistor) circuit, to compensate for circuit loss to oscillation.
What else can I help you with?
What are the advantages of wien bridge oscillator?
RC phase shift oscillator is used to generate frequency in audio range and it is a fixed audio frequency oscillator where as wien bridge oscillator is a variable audio frequency oscillator for high frequency oscillations it is better to design wide band amplifier with LC network
Why RC oscillators are not suitable for high frequency generation?
Because an RC oscillator is affected by stray capacitance in the active components in the circuit. HF oscillators use an LC tuned circuit to define the frequency.
What are the advantages of clap oscillator?
clapp oscillator have frequency more stable and accurate than colpitts oscillator.
What is a Colpitts oscillator?
A Colpitts oscillator is the electrical dual of a Hartley oscillator. The Hartley oscillator is an LC electronic oscillator that derives its feedback from a tapped coil in parallel with a capacitor. http://en.wikipedia.org/wiki/Colpitts_oscillator http://en.wikipedia.org/wiki/Hartley_oscillator ~MECHASUN~ A Colpitts oscillator is the electrical dual of a Hartley oscillator. The Hartley oscillator is an LC electronic oscillator that derives its feedback from a tapped coil in parallel with a capacitor. http://en.wikipedia.org/wiki/Colpitts_oscillator http://en.wikipedia.org/wiki/Hartley_oscillator ~MECHASUN~
What is a frequency range of LC oscillator?
depends on the oscillator and its purpose
Classification of oscillators?
Phase-shift oscillator Armstrong oscillator Cross-coupled LC oscillator RC oscillator
What is type of oscillations?
Phase-shift oscillator Armstrong oscillator Cross-coupled LC oscillator RC oscillator
What are the Difference between RC oscillator And LC oscillator?
The difference between an RC and LC is that the frequency - determining device in the RC oscillator is not a tank circuit. LC can operate with A or C biasing, while RC can only operate with A.
Is RC phase shift oscillator more stable than a crystal oscillator or not?
no
What is name the form RC networks?
The name for an RC network is an oscillator.
Which is better RC phase shift oscillator or wien bridge oscillator?
phaseshift of wienbridge is 0
What is the application area of RC oscillator?
They are used in electronics.
How many emitter stage is needed to build up an RC phase shift oscillator and wien bridge oscillator?
In an RC phase shift oscillator, one emitter follower stage is typically used to provide the required phase shift. In a Wien bridge oscillator, two emitter followers are used to achieve the required feedback and oscillation.
What are disadvantage of lc oscillator over the RC oscillator?
DISADVANTAGES OF RC PHASE SHIFT OSCILLATOR.1. The output is small due to smaller feedback. 2. It is difficult for the Circuit to start oscillations.3. The Frequency stability is not so Good.4. It requires high Vcc. For large feedback.
Why only 60 degrees phase shift in RC phase shift oscillator?
In order for an oscillator to be stable, its total phase shift must be 180 degrees. The most common design of an RC phase shift oscillator is three identical RC stages in series, which means that each stage contributes 60 degrees. For more information, please see the Related Link below.
What are the advantages of wien bridge oscillator?
RC phase shift oscillator is used to generate frequency in audio range and it is a fixed audio frequency oscillator where as wien bridge oscillator is a variable audio frequency oscillator for high frequency oscillations it is better to design wide band amplifier with LC network
Why you use crystal in 8051 microcontroller?
for accurate time rc oscillator is common in non time critical stuff
