The symbol for a relay is in two parts, and it's rather difficult and ineffective to describe verbally. Therefore, I added a direct link to an image of the accepted symbol to the "Related Links" section.
A circle with an X on it.
When a bulb fuses the circuit is broken if it is on a serial circuit. If the bulb is on a parallel circuit, only the fused bulb will go out, any other bulb would remain lit. On a serial circuit, until the bulb is replaced by a new one, the circuit is not able to be used.
It doesn't matter where the bulb is in respect to the battery, as long as the circuit is complete, the bulb will light up.
To provide electricity for the bulb to light up.
The question is ambiguous, however one possibility is a parallel circuit, which would permit one light bulb to remain lit while the other light bulb was switched off. By contrast, if the light bulbs were connected in a series circuit, switching one light bulb off would cause both lights to go off.
Nothing much will happen except the same bulb will not blow..
A circuit symbol is a symbol that represents a component in a circuit. For example a light bulb is a circle with a cross in it.
A circle with an X on it.
there is a symbol of bulb,galvanometer,voltmeter,ammeter,gong,paperclip,switch,wire,solenoid,bulb and armature
The bulb is the load of the circuit, without it you have a short circuit.
A light bulb can be part of a circuit.
A parallel circuit will not effect the other bulb. If the bulbs are in a series circuit the other bulb will not turn on.
If the bulb's filament is broken, the whole circuit becomes open. If the bulb is in a series circuit or is the only bulb, the electricity would no longer flow. If the bulb is in a parallel circuit, along with other bulbs, then only the blown bulb would go out, and the other bulbs would still work.
When a bulb fuses the circuit is broken if it is on a serial circuit. If the bulb is on a parallel circuit, only the fused bulb will go out, any other bulb would remain lit. On a serial circuit, until the bulb is replaced by a new one, the circuit is not able to be used.
It completes the circuit!!
In electrical engineering there are many types of symbols used to notate devices. These include symbols for polarity, switches, diodes, and batteries.
It doesn't matter where the bulb is in respect to the battery, as long as the circuit is complete, the bulb will light up.
The whole circuit fails - because the action of the bulb blowing cuts the circuit.