903-714-1075
call for a good time.
n00dz 4 n00dz
-Nolan S.
The difference between silent film and sound film is because that silent film has no sound whatsoever and a sound film has sounds in it
What you learn from the film Amadeus about the difference between talent and genius is tha talent is more appreciated. Genious is sometimes looked down upon. Those with talent get treated better.
The amount of money available to make your movie (independent = less money).
There is no difference: these two elements are often combined. Both are used essentially for entertainment, although out of context, one could say that film can also be used for evidence, which is not necessarily true of drama. Your question is like asking about the difference between a grape and a potato -- they are both food.
Oil film refers to a thin layer of oil that forms on surfaces, typically as a result of lubrication in mechanical systems or when oil is spilled on water. In lubrication, it helps reduce friction and wear between moving parts, protecting them from damage. In environmental contexts, oil film can create a sheen on water surfaces, affecting aquatic life and ecosystems. Overall, oil films play significant roles in both industrial applications and environmental issues.
Boundary lubrication is a lubrication regime where the lubricant film is insufficient to fully separate two surfaces in relative motion, leading to direct metal-to-metal contact. This results in increased friction and wear. Boundary lubricants are often used to provide protection in situations where full fluid film lubrication is not achievable.
To provide a film of lubrication between metal moving parts.
The difference is that hydrodynamic lubrication requires the motion of the moving parts that are to be lubricated to pump the actual lubricant. Electrohydrodynamic lubrication involves electrically charged lubricants.
Full film lubrication is a term used in hydraulic pumps and motors to describe the state of oil film between a stationary distributor plate and the rotating parts of the pump or motor.
Boundary Lubrication (sometimes referred to as thin film lubrication) is a condition in which the lubricant film becomes too thin to provide total separation. This may be due to excessive loading, speeds or a change in the fluid's characteristics. In such a situation, contact between surface asperities (peaks and valleys) occurs. Friction reduction and wear protection is then provided through chemical compounds rather than properties of the lubricating fluid. Boundary lubrication often occurs during the start-up and shutdown of equipment or when loading becomes excessive. This condition can commonly be observed in certain types of gear sets that need to withstand sliding pressures and shock loading such as hypoid gear sets found in automotive differentials.Please see related link below!
The difference between silent film and sound film is because that silent film has no sound whatsoever and a sound film has sounds in it
Difference between thick and thin film resistor is not related to thickness but its based on how the film is applied to the surface.
A. Z. Szeri has written: 'Fluid Film Lubrication, 2nd ed.' 'Fluid film lubrication' -- subject(s): Fluid-film bearings
they have differe.nt method of deposition of film of conducting material. Hence, the difference between two is their fabrication process.
there the same
A digital film is stored and played from a hard drive. Technically its not film at all.
under conditions of heavy load and low speed a thick film of lubricant cannot work ,under these conditions,boundary lubrication occurs.in other words ,this type of lubrication cannot persist ,and metal metal direct contact is possible for some reasons.such a situation develops when 1)the viscosity of oil is low 2)the load is fairly high 3)the viscosity of oil is low 4)a shaft starts moving from rest