The function of a zener diode is for it to act as a voltage regulator in the breakdown region.
Dr. Clarence Melvin Zener of Southern Illinois University invented the zener diode.
Silicon "zener diodes" with a zener voltage rating of 5.6V or higher operate mainly by avalanche breakdown, so both the 6.2V and 24V "zener diodes" are avalanche breakdown type (not zener breakdown type).
Yes. The intended use of a zener diode is to be reverse biased at the breakdown voltage. In this mode, the zener has high slope in the current to voltage curve, making it a good choice for voltage regulation.
A zener diode has a heavily doped p-n junction allowing electrons to tunnel from the valence band of the p-type material to the conduction band of the n-type material, such that the reverse voltage is "clamped" to a known value, called the zener voltage.
When the design says 4.9v zener diode that is all I would put. The more complicated an alternative you try the more things that can go wrong. A silicon diode is not the same as a zener diode, and cannot be used to replace a zener, with reasonable expectation that the circuit will continue to operate as designed.
zener diode is a revers bias diode which used for voltage regulation.
The difference between the pn-junction diode and the zener diode is that the pn-junction diode is used for rectification while the zener diode is used for rectification and stabilization. Also, the zener diode can function in the breakdown region while the pn-juntion diode can not function in that regime.
A zener diode, in the reverse bias condition, presents a higher voltage. The current, however, is a function of the supplying circuit.
sharp reverse breakdown function
A Zener barrier is an intrinsic safety equipment. It allows short circuiting of cables to each other or to metallic parts connected to ground without danger.
zener resistance of a zener diode is the resistance of the zener diode but which is the resistance of a diode
a zener regulator must sustain its own current to function plus the load currents IC regulator on the other hand will require very little current to sustain regulation plus there is a gain regulation that a zener do not have.
In the zener region of a diode, there is a relatively flat, low slope line for voltage as a function of current. As a result, increasing current in the zener region does not result in a significant increase in voltage - hence, voltage stability.
The dynamic resistance of a diode, be it zener or otherwise, will be different from its static resistance because a diode is not a resistor, and resistance is not a function of current flow. It is a diode, and a diode has its own characteristic voltage to current curve, forward and, in the case of a zener, reverse.
Dr. Clarence Melvin Zener of Southern Illinois University invented the zener diode.
charles zener
Clarence Zener was born in 1905.