For use in networks the maximum segment length would be 500 meters
That would be the Earth's distance from the Sun (at aphelion) plus the Earth-Moon distance. The latter is insignificant.
The maximum distance between fire sprinkler, per NBC, depends on the sprinkler system. The size of the sprinkler and the number of sprinklers need to be considered when installing.
Yes it will.
Most times they are the same but a satellite signal needs to be carried by RG6 cable it is a heavier gauge wire then say RG59. Regular or analog cable signal is sometimes carried by RG59 but digital cable should use RG6. +++ The primary specification is not conductor size but the impedance and capacitance of the cable.
The sheave height is the distance between the shortest distance from the tip of the sheave (commonly called a "boom") and the ground. It is common to discuss the sheave height with respect to a piece of equipment and get a number which is the maximum sheave height.
For Dish Network, we use RG6 coax cable to allow a higher frequency range for the satellite signal from the dish to your receiver. Any coax cable not rated at RG6 could affect the signal.
Depends on the coax type - thinnet coax is 185 meters per segment, thicknet is 500 meters
This would depend upon your TV and the receiver and if it has a coax port available on the back. You can use an RG6 coax cable between the receiver and TV. Most newer HD receivers do not have a coax port on the back
The type coax you need depends on the type service you have. For satellite service, we use a higher rated coax cable (RG6) to allow for a higher frequency for channels and back feeding capability. RG59 is a lower rated cable.
We use a RG6 coax cable from the dish to the receiver. The cable used between the receiver to the TV varies.
Depending on WHICH coax MG, anywhere from 900-1100 meters.
185 m
coax is 200 meter maximum ,if you want more than 200 meter(video transmission) you can even use cat 5 cable with video transmitter and receiver adapters and it will be the cheap and best way. futronicservices@gmail.com
750 feet (228 m)
Yes if you have a dual LNB(2 coax ports) and RG6 coax cable run to both receivers.If you don't grab one off eBay just make sure it is the same shape as your mount arm and for the correct satellite provider.
It depends on the quality of the cable (how much copper it has) and the gauge of the wire. The most common type of gauge is 18 AWG. Also, the weight depends on the type of packaging - wooden spools are the most common. An 1000' spool of 18 AWG coax on a wooden spool weighs 38.6 pounds.
You can install the 110v line on one stud and the coax jack on any other, just don't put them on the same stud. This will cause major crosstalk in the coax line.