The inductor symbol resembles a coil of wire of 3 to 5 turns.
In DC inductor is short circuited .
The fundamental purpose of an inductor is to store electrical energy in a magnetic field.
The opposition to an alternating current offered by a coil, or inductor, is called impedance (symbol Z, measured in ohms) which, in turn, is made up of two components: resistance (symbol R) and inductive reactance (symbol XL). These three quantities are related as follows: Z2 = R2 + XL2.The resistance of an inductor is a fixed value which depends upon the length of the coil's wire, the cross-sectional area of the wire, and the resistivity of the material from which the wire is made.The inductive reactance of an inductor, on the other hand is directly proportional to the frequency of the supply. So, at high frequencies, an inductor's inductive reactance is very much higher than at low frequencies.So, at high frequencies, the impedance of the inductor is higher because its inductive reactance is higher.The current flowing through a coil is, by Ohm's Law: I = V / Z. So, at high frequencies, the inductor's impedance will be much higher than at low frequencies, which means that a very much smaller current will flow when the frequency is high compare to when the frequency is low.
Inductor is a nonlinear device. since v=L di/dt.
The resistance of an inductor is generally referred to as the series resistance, sometimes noted as RL. Note that resistance is a DC measurement and that an "ideal" textbook inductor has an RL of 0. The reactance of an inductor is an AC measurement which measures the reaction of a component's current flow to an alternating voltage and is frequency dependent and directly proportional to the inductor's inductance, measured in Henrie's. The impedance is most commonly used when talking about inductors or capacitors and is a combination of resistance and reactance.
letter symbol is L
inductor was invented by scientist lenz so it is denoted by l..
L is the symbol for inductance. An inductor is a passive two-terminal electrical component which resists changes in electric current passing through it.
what is an inductor used for
Since we know that inductance of an inductor depends on the length of inductor by the formula L=muAN*N/l, where l is the length of inductor. So by varying the length of inductor we say that inductance of inductor varies.
In an ideal inductor, no, there is no voltage induced across an inductor unless the current in the inductor is changing. However, since there are no ideal inductors nor power supplies, eventually an inductor will draw a constant current, i.e. the limit of the power supply; and, since no inductor has zero ohms at equilibrium, that current will translate to voltage.
any conductor wound with few turns can be considered as an inductor
An inductor looks like a piece of wire to DC. It will thus look like a resistor, and inductor properties do not apply.
A changing current through an inductor induces a voltage into the inductor, the direction of which always opposes the change in that current.So, in a d.c. circuit, an inductor will oppose (not prevent) any rise or fall in current, although the magnitude of that current will be determined by the resistance of that inductor, not by its inductance.In an a.c. circuit, because the current is continuously changing both in magnitude and in direction, it acts to continuously oppose the current due to its inductive reactance. Inductive reactance is proportional to the inductance of the inductor and the frequency of the supply. The vector sum of the inductive reactance of the inductor and the resistance of the inductor, is termed the impedance of the inductor. Inductive reactance, resistance, and impedance are each measured in ohms.
a coil. a component having the property of inductance.
In DC inductor is short circuited .
The fundamental purpose of an inductor is to store electrical energy in a magnetic field.