Coleman powermate
Yes, the amp hour rating gives you an idea of the capacity of the battery and charger. The charger and battery need to have the same voltages. i.e. dont try to charge a 6v battery with a 12 v charger. The battery will be charged until it is full.
The PS3 controller does not need a charger. Just purchase a Sony PS3 cable and plug into any USB port. Mine is plugged into my Sony HDTV
No, since in series they are 24 volts so you need to charge each one independently with the 12 volt charger. This may be done disconnected or leave them connected and put the charger on the + - of the same battery.
It's a good idea to avoid charging any battery with a charger that was not designed specifically for that kind of battery. A car (vehicle) charger is generally designed to recharge 12 volt lead acid batteries. (The actual voltage of the battery and charge is a bit higher than 12 volts.) Rechargable battery packs come in different voltages, and many if not most are not lead acid types. A lot are nickel-cadmium or lithium types, and they need a "controlled charge" that a vehicular battery charger will not be able to provide. And that's setting aside the issue of the voltages of the battery and the charger, which is critical.It's a bad idea to attempt to recharge a battery with a charger that is not designed to recharge that "flavor" of energy storage device.
Without knowing the maximum output current it was designed to produce it isn't possible to say exactly how much voltage a charger produces. Also, was it intended to give a slow or a fast charge? In general all that can be said is that the output voltage of a battery charger must always be slightly higher than the nominal voltage of the battery it was designed to charge. This is for the simple reason that it won't be able to put any charge into the battery unless the charger's "on-load" voltage is higher than the battery's voltage. For the same reason, a charger which can deliver a high output current (amps) will need a higher "on-load" output voltage than a charger which can only deliver a low current. Also, when it is switched on but is not connected to a battery, the output voltage of any charger will always be higher than when it is doing its job of charging a battery. That voltage is called the "no-load" voltage. Assuming the battery being charged is a standard low-voltage type, of less than, say, 24 volts DC, it is quite safe, using a standard electrician's voltmeter, to measure the load and no-load voltages of the charger as described above.
you cant!! you need a charger
People feel like they need to be in the spotlight because they want all the attention on them.
If the charger plug will not fit into the jack, you have the wrong charger. You need to find the right charger for that device.
form_title= iPhone Charger form_header= Keep your phone charged with an iPhone charger. Do you need a USB charger?*= () Yes () No What model iPhone do you have?*= {3, 4, 4S, 5, Other} Do you need a car charger?*= () Yes () No
Yes, it comes with a charger.
No it does not, you need to use your ds charger.
where do i buy a doss charger
No, the Nintendo Wii does not need a charger, but requires electricity to run. Therefore, it will need to be connected to an outlet to work
Yes, you need to use a trickle charger or a very small charger such as one smaller than 5 amps.
No you don't need a special charger for NMmh. Depending on the capacity you may need a fast charger, otherwise it would take you a lot of time to charge.
2-volt batterys I need the charger for this 20 million CP light
You will need a CR05 TRAV - AC/DC Kodak C340 Battery Charger.