Ohm's law states that "The current is directly proportional to the applied EMF (voltage) and inversely proportional to the resistance in the circuit."
AnswerIf the voltage across a circuit increases, then the current will increase too. If the ratio of voltage to current is constant for variations in voltage, then the circuit is described as being 'linear' and is obeying Ohm's Law; if the ratio of voltage to current changes (as it would, for example, with tungsten) for variations in voltage, then the circuit is described as being 'non-linear', and is not obeying Ohm's Law. This is because Ohm's Law is not universal, and only applies to certain materials; in fact, most materials and electronic devices do not obey Ohm's Law.
Ohm's law states that "The current is directly proportional to the applied EMF (voltage) and inversely proportional to the resistance in the circuit." <<>> if resistor exists, resistance decreases according to ohm's law, current is directly proportional to voltage and current is inversely proportional to resistance it means as current increases, voltage increases. resistance increases, current decreases so as voltage if there is no resistor, there should be no resistance except internal resistance of voltmeter and ammeter
What happens to the current in a circuit as a capacitor charges depends on the circuit. As a capacitor charges, the voltage drop across it increases. In a typical circuit with a constant voltage source and a resistor charging the capacitor, then the current in the circuit will decrease logarithmically over time as the capacitor charges, with the end result that the current is zero, and the voltage across the capacitor is the same as the voltage source.
"Ohms Law" defines resistance (R) as the the ratio of voltage (V) to current (I).R = V/IIf you move those variables around, you can get the formula:I = V/RSo you can see that when resistance increases, current flow will decrease.CommentResistance is most definitely not defined as 'the ratio of voltage to current', although that ratio may tell you what it happens to be.Resistance isn't a variable in the Ohm's Law equation. It is a constant because it is unaffected by either current or resistance.
capacitors
It gets brighter.
Voltage remains constant; current increases.
After breakdown voltage is reached in a zener diode the current increases drastically.
If resistance increases and voltage stays the same, then current decreases. Ohm's Law: Current equals Voltage divided by Resistance.
As the resistance is reduced across the same voltage, the current increases.
nothing
Voltage attempts to make a current flow, and current will flow if the circuit is complete. It is possible to have voltage without current, but current cannot flow without voltage. The answer is "yes",voltage remains the same as current moves through the circuit.As the voltage remains constant, current increases in the circuit.
A: Perfect example is a zener. As input voltage increases the current at the knee increases almost linearly at the zener voltage. If the inputs varies up or down then the current will vary up or down at the preset voltage making a zener a voltage regulator because of this feature
In the graph of voltage vs current, the relationship between voltage and current is linear. This means that as voltage increases, current also increases proportionally.
P=VI If current (I) increases then P will increase proportionally. That is, assuming that voltage (V) remains constant. If voltage decreases and current increases or vice versa, proportionally then P will remain the same.
Yes, if the resistance remains constant. Power is voltage times current, and current is voltage divided by resistance, so power is voltage squared divided by resistance. In essence, the power increases as the square of the voltage.
The current vs voltage graph shows that there is a linear relationship between current and voltage in the given circuit. This means that as voltage increases, the current also increases proportionally.
If current increases, then voltage also has to increase, assuming that resistance stay relatively the same. Power will also increase. Since power is the product of voltage and current, then the power increase would be the square of the voltage or current change.