daisy chains are strings or loops of actual growing daisy flowers. To make a ckain, you pluck a blossom with about 2" of stem. With your fingernail, make a slit along the stem so that you can slide the stem of the second daisy through it..DON'T PUSH IT ALL THE WAY THROUGH. When the blossom of the second daisy reaches the slit in the first stem,STOP!!
Now,holding the 2 stems together, slit the second stem just like the first and insert a third daisy stem into this slit.
Now,holding the three daisies in a chain together,make a slit and insert a fourth stem.
continue until your daisy chain is as long as you wa-ooops- one of the slits in the chain etended to its end and broke that segment.
you did all that work before and after the break,but the daisy needs fixing.
my grandmother taught me how to daisychain.
The tiny piece of silicon onto which electronic circuits are embedded is called a die.
Chip
It depends somewhat on context. A dc circuit consists of of a flow of current to the load and back to the source. This is often called the loop. The loop resistance would be the total resistance measured in ohms. In most power circuits the above would hold true in an ac circuit as well.
A short move of current events is called a newsreel.
Simple parts of a circuit are switches, light bulb, battery and connecting wires.
The charged particle that flows through circuits is an electron.
The current in electrical circuits is the flow of electric charge. It is measured in amperes (A) using a device called an ammeter. The ammeter is connected in series with the circuit to measure the current passing through it.
Capacitive reactance.
That flow of energy through systems or circuits is called current. Current is the movement of electric charge carriers, like electrons, through a conductor in a particular direction due to the presence of a potential difference.
That is called a fuse. A fuse is a protective device, which will interrupt the flow of electricity if it is subjected to a current that is greater than its rating. Some fuses are designed to handle a large inrush of current and are used in circuits such as air conditioners, where a large amount of current is needed at startup, for a short duration and then current drops to a lower level. These are sometimes called time-lag fuses.
A temporary source of an electric current is called a battery. It converts chemical energy into electrical energy to power devices or circuits.
Sequential Logic circuits are a type of logic circuits in which its output depends on the current and last input (memory). a digital circuits that contain filp-flop is called as sequential ckt because its output at any time depend not only on its current input but also past sequence memory of past event.
Transferrer
Sequential Logic circuits are a type of logic circuits in which its output depends on the current and last input (memory). a digital circuits that contain filp-flop is called as sequential ckt because its output at any time depend not only on its current input but also past sequence memory of past event.
Analog circuit continuous uses the time voltage and currents while digital circuits are sometimes called the on/off and high/low control of voltage in circuits.
This question makes no sense whatsoever without giving details of "the board" being asked about...There is no point in copying and asking this kind of incomplete fragment from such a homework or exam question.
Yes.