First it is very important to chose the right microphone. There are condenser microphones, ribbon microphones, dynamic microphones, and there are electret microphones. There are some different characteristics: omni directional, wide cardioid, cardioid, super cardioid, hyper cardoid and figure-of-eight. There are microphones with small diaphragm diameters and with large diaphragm diameters. There are expensive high quality studio microphones and less ideal very cheap Chinese mics. When you have found the right microphone, then you can start to ask where to put this microphone to which musical instrument or voice.
my name is hi-low, piccolo, piccalo hi low hi lo piccalo piccalo no name
High music, low music, its becuz some notes are high, some sound low.
D(low)d(low)a,a,a e,f(natural) e d(low) A,c(high) d(high) c(high) a,b(natural) g a,d(high) d,d(both high) c(high) a a,g,f e d(Low) a g,f e, d(low) e d(low)
I don't know because i asked this same exact question in yahoo answers and i dont think anyone has answered it. Lookin for the same song i bet...hope you find it
The article will tell you about the basics of microphones and audio boards. Hope this helps.
Rodes makes microphones for the iPhone and iPad. Their microphones broadcast quality sound, contain low noise circuitry, and are made out of high metal construction.
ascending
this site (FreshDeals.com) has great pro and semi-pro microphones a very low prices, and have fast shipping.
Lavalier microphones may be purchased online at low cost from Dino Direct or Guitar Center. They have a variety of entry level models and offer nice shipping deals.
A saturated fuel injector is also known as a High Impedance (or High z) fuel injector. The high z injector has a larger ohm draw through the coil (12v-15v) vs. a peak-hold (Low Impedance, Low z) injector, which is 2v-4v. Another difference is the how the injector uses the voltage to open the injector. A high z injector uses the full voltage to open and hold open the injector, therefore it voltage saturated. A low z injector (peak-hold) has a peak of high voltage to open then injector then uses a lower voltage to keep the injector open for the remainder of it's cycle. What this means to you, the low z injectors typically needs a resistor in line to add the necessary resistance to properly drive the system, otherwise the injectors could overheat to fatigue. A high z injector does not need a resistor.
capacitor is the elementZ=1/wc if w is less Z is high making current low
The port with the black cap on it is the low side as the red cap is the high side.
Microphones are manufactured in many countries around the world. Some prominent countries known for producing microphones include the United States, Germany, Japan, and China. The country of origin for a specific microphone would depend on the brand and manufacturer.
You need different types of microphones for different types of sound sources. For example, for a bass drum, you would need a microphone with the ability to catch low-frequency sound waves. For tom-toms or a snare drum, you need microphones that can pick up very loud (high SPL) sounds. For choirs, you need microphones with very large pick-up patterns. You need smaller microphones to be discreet. Vocal microphones onstage need to have excellent rear-rejection to help eliminate the risk of feedback from the mains or monitors.For live situations, omnidirectional microphones are not suitable because of the risk of feedback. Whereas with recording, different pick-up patterns can be more safely used.Most microphones (other than the Shure SM57 or similar mics) have a specific use that the mic is best suited for.
IPod microphones are best suited for recording audio directly to the Ipod. The high performance microphones like alesis ProTrack or Belkin GoStudio can turn the Ipod into a full-fledged mobile recording studio.
z n