0
What else can I help you with?
In the 1994 Jeep Grand Cherokee with the Infinity Gold System are the amps located in the spearkers?
If it's the same as my '96 the amp is under the rear seat. Just pull the release strap for the bottom part, it should be underneath. Mine is on the drivers side.
If 180 pounds of peas are packed in 34-pound bag how many bags will there be altogether?
180 divided by 34 180/34 = 5.29 bags So6 bags or 5 and a little bit left over
What does a marimba weigh?
180 lbs
How much does riff raff weigh?
180
What is Taylor Swift Height?
5'11 (180 cm)
How many amps will 2-2-2-4 carry at 180 feet?
150 amps
180 milliamps equals how many amps?
1,000 milliamps = 1 amp 180 milliamps = 0.18 amp
How many amps can 4 ought aluminum wire carry?
Aluminum 4/0 wire car carry 180 amps at at 75 degrees Fahrenheit or 205 amps at 90 degrees. .
How many amps do you need to supply a 150kva transformer to get 118amps 480 volts?
Rephrase your question, as it doesn't make any sense. If the primary side of the transformer is 480 volts 3 phase, this transformer can be supplied from a breaker as big as 180 amps. If 480 volts 3 phase is your secondary then you can supply up to 180 amps to your loads.
What does battery of 180 AMP HOUR mean to you?
it means battery can deliver 180 amperes per hour if driven at full load I.E, isa an application setup whican draw 180 amps is connected to a battery of 180 Ah it will delivery current till one hour . Chandra sekhar
How many amps are available in a three phase 225 amp panel?
In a three phase 225 amp panel, there would be a total of 225 amps available for each phase, making it a total of 675 amps for all three phases combined. This means that you could have up to 225 amps of current flowing through each phase simultaneously.
What is the sum of the measures of the interior angles of a 20 sided polygon?
The formula that I use is (n-2)180 where n=number of sides. Plug in 20 and you get (20-2)180 (18)180 3240 degrees
Where is the radiator drain plug located on a 1999 Saturn?
Radiator drain plug is located on the bottom of the radiator on the passanger side. you may have to remove the lower splash shield to gain full access to the plug. to open the plug turn it 180` and pull out.
How much power does a DC to AC inverter use when not used?
One 150 watt inverter reports 0.2 Amps (=approx 2.4watts) Another inverter (180 watts?) reported 0.4 Amps If you find a fairly complete spec sheet, it may tell you the Amps or Watts that it uses under "No Load". I'm the originator of the question, and I discovered the "additional" specs.
What is 1.5amps 115 volts equal to in watts?
There really is no fixed answer. Amps are a measure of current, while watts are a measure of work. To get the answer, you need to know either how many volts you are dealing with, or how much resistance; the relationship is W= V*I (where I is the current in amps). That said, for a typical 120 volt household current, the number of watts would be 180.
What is the formula to figure out how many plugs and lights you can put on a circuit?
This depends upon the circuit breaker capacity. You may never load a circuit to greater than 80% of it's capacity. So you may load up to 12 Amps on a 15 Amp circuit, and, 16 Amps on a 20 Amp circuit. The National Electrical Code requires you to calculate each receptacle at 180 VA. If the circuit is 120 volts and 15 amps, you would have 1800 VA, divide by 180 VA per receptacle, equals 10 receptacles per circuit (minus the wattage of each luminaire or light fixture added to the circuit, before dividing by the 180 VA). If the circuit is 120 volts and 20 amps, you would have 2400 VA, divide by 180 VA per receptacle, equals 13.333 receptacles per circuit (round down to 13 receptacles),(minus the wattage of each luminaire or light fixture added to the circuit, before dividing by the 180 VA).
For 200 amps service do you use 100 amps per 120 volt leg?
In a 200 amp service, each leg carries 100 amps. However, since the legs are 180 degrees out of phase, you can achieve 240 volts across both legs. So, a 200 amp service typically consists of two 120 volt legs, each providing up to 100 amps.
