Yes, it actually happened to me once. My string broke during rehearsals so I had to change it. Since the old string cut into two, I accidentally touched the sharp edge & it cut through my middle finger. Of course, my finger bled. So you just have to be very careful about changing strings next time, be vigilant as to if your string has a sharp edge or not.
violin strings
A ukulele is played by strumming the strings, which are in a flat across arrangement. A violin is played using a rosined bow pulled and pushed across the strings, which are in a curved arrangement.
Violin strings are held on a violin with tuning pegs. The pegs are then turned until the strings reach the correction tension. The correct tension is when the strings are in tune. Adding more tension to a string by turning the pegs will increase the pitch and turning the pegs in the opposite direction will lower the pitch. The strings on a violin are tuned to the notes G D A E from lowest to highest.
Violin and harp would go into the strings category of the family of instruments...The other families are:Brass-windWoodwindElectronics (Electronic Bass & Guitar)I dont remember the others... I am going to post A QUESTION...
The violin is the smallest member of the string family.
You can pluck the strings with your fingers. This method is called pizzicato.
I assume you mean a chord. You can do this by placing fingers on both strings that you want to play and playing the strings at the same time.
violin strings
The notes on a violin are produced by pressing the strings against the fingerboard with the fingers of the left hand and then bowing the strings with the right hand. The pitch of the note is determined by the length of the vibrating portion of the string.
A ukulele is played by strumming the strings, which are in a flat across arrangement. A violin is played using a rosined bow pulled and pushed across the strings, which are in a curved arrangement.
Violin strings are held on a violin with tuning pegs. The pegs are then turned until the strings reach the correction tension. The correct tension is when the strings are in tune. Adding more tension to a string by turning the pegs will increase the pitch and turning the pegs in the opposite direction will lower the pitch. The strings on a violin are tuned to the notes G D A E from lowest to highest.
A standard violin typically has four strings.
To play a violin effectively, you need to use a bow and your fingers to press the strings on the fingerboard in the correct positions to produce different notes and melodies.
sure u should trim them constantly DEPENDING on your level
A broken violin.
Because it has strings.
it is similar to most string instruments (like violin, viola, double bass) we can pluck the strings using our fingers or bow it.