Want this question answered?
Disconnect the 2 wires from the switch and connect them together
its called wires and its by athlete
do not cut the wires. buy plug .
take the nose plastic off disconnect the wires going to the top off the carb , and the wires coming out of the thumb throttle then looking at the front of the the bike on the right there is a small silver box with the same kind of plug in as the ones you already unplugged unplug that box and put the bike back together .
firstly take out the old stereo.. using a voltameter find the 12v supply cable.. this should always be on even when ignition is off then find the accessories power cable with the ignition turned to on. hook up the earth cable on any metal surface in the car use a 6 volt battery to find the speaker cables go thru the wires until you hear a "pop" sound and this will indicate which speaker is from which wires. hook up all wires (for a better installation solder the wires and cover with tape but if you cant sodler just twist together and tape) and replace stereo in the dash.
it works because all the wires inside of it and there is over 200 wires inside of a electric blanket
For getting proper earthing. And it will reduce the chance for getting electric shock
Making a load On, By using a clamp meter for measuring the current in the wires : we find a reading in Amps. if we clamp the neutral wire. and zero when clamping the earthing wire.
he kept popping out of bed
He kept popping out of bed
copper wiring would be best for heating floor tiles.
No glue is used for copper. Copper wires and pipes are soldered together. This involves heating both pieces and melting a lead/tin wire into them.
You can splice wires together in many ways. You can solder them together and then tape them up or use a shrink insulator that shrinks by heating it up. You can strip the wires back about 1/2 inch and then twist them together and put them under a wire nut. Wire splices in a home must be spliced together inside a junction box with a cover. Wires can never be spliced behind a wall. Any splice should be placed where you can access it later on.
The best place is in Califorinia called Me and blankets.
Line loss, or heating of the wires. The insulators prevent the loss of energy.
Because the amount of heating depends on how much current is in the wires. So you set the CB to cut the current if it exceeds the rated current for that wire.
A: Nobody does that. Wires are good conductor never are to be used to heat anything, But there are special wire to do the heating