please can you help me to remove my stereo, for Camry Toyota 1996, show me a picture then i will follow
Remove the 1993 Toyota decorative radio cover in. Remove the radio retaining screws. Pull the radio out. Remove the wiring harness.
the following website gives detailed information on how to remove and reinstall the 1996 Hyundai elantra radio, i just used this to replace my own radio today. Hope it helps! http://www.hmaservice.com/webtech/iindex.asp?id=3212&modelyr=1996&modelid=5&enginemotormmc=10&pre=0&reviewed=1#_3212
Remove the cup holder and ashtray assemblies, pull the dash face off (tilt the stearing wheel all the way down). Then remove the bolts that hold the radio in the dash, pull the radio out and unhook all the wires from the back.
Remove the plastics with a flat head screwdriver (be careful not to break the plastic clamps) surround the face fo the radio. Unscrew (should be four) screws remove radio and make sure to disconnect wiring harness and ground wire. Enjoy.
Radio Comix was created in 1996.
Remove the 1993 Toyota decorative radio cover in. Remove the radio retaining screws. Pull the radio out. Remove the wiring harness.
how do i remove the valve cover to change the gasket in a toyota camry 1996
how do u remove the radio from 1996 f 350 ford truck
you can pop off the front panel with small screwdriver then there are 4 screws that are phillip unscrew the 4 bolt and it should fall out
drain fluid, then remove hoses and unscrew four screws.
Remove the wheels, pry the drums off.
Remove the decorative radio retaining plate. Remove the retaining screws. Pull the radio out. Remove the wiring harness. Remove the antenna cable.
how you can remove the knock sensor from a 1996 Nissan pathfinder i need a picture
you eat it
You have to remove the door panel, after that you will be able to replace the speaker.
I need to replace radio CD player from 1995 Avalon
You can replace the radio, on your 1996 Toyota, I removing the radio front cover. Remove the retaining screws. Unplug the wiring harness. Reverse the process to install the new radio.