0
What else can I help you with?
Will a 2004 stock Jeep Grand Cherokee CD player fit a 2000 Jeep grand Jeep Cherokee?
NOT without a custom wire adapter. BestBuy mobile, or eBay The holes for the screws will fit, the wiring is complete different in the 1999-2000 than the 2001-2004 models. But it is possible
What does code p0420 mean and what you need to do?
Code P0420 is a code for Catalyst efficiency. The computer is seeing the post Catalytic converter o2 sensor having too much activity. The Cat. should be cleaning the exaust of Hc, co, and Nox. The post cat o2 will read the o2 content in the exhaust and if it moves up and down too much or to high and low, the computer interperates that as the cat not ridding the exhaust of it's pollutants. This indicates that the converter is unable to preform properly. The problem could be a bad cat, o2 sensor (Pre- and/or post cat)or o2 sensor wires, or an air fuel mixture problem that has caused the cat to fail. Many other engine operating system failures can cause the converter to not work properly.
Why is the passenger floor of your 96 jeep grand Cherokee wet from the air conditioning?
b CAUSE U HAVE A LEAK There could be a body plug that has came loose or fallen out completely. Get up under ypur vehcile and check for any holes. if there is one missing. replace it. I had this happen in another vehicle right after the windshield was replaced. The windshield wasn't sealed properly. After a heavy rain, I had about an inch of water on the floor board. After I took it back and had them reseal the windshield, the problem was gone.
What are the f holes in a cello called?
The F holes in a cello are called... <drum roll!> F-holes! They are also called 'sound holes', and acousticians might refer to them as 'ports'.
Finger holes part of bagpipesfinger holes part of bagpipes is called?
The finger holes on bagpipes are typically referred to as "finger holes" or "tone holes." These holes are used by the player to change the pitch and create different notes by covering or uncovering them with their fingers. In some types of bagpipes, such as the Great Highland bagpipe, there are also additional features like a chanter, which is the melody pipe that incorporates these finger holes.
How do you weld holes in catalytic converter?
A catalytic converter with holes in it needs replacing. It affects not only emissions, but the performance of the engine. Replace the converter.
Can you poke holes in your catalytic converter?
no
Symptoms of bad catalytic converter 94 lumina?
Some symptoms of a bad catalytic converter on a 1994 Lumina are engine stalling, engine backfiring, no start of engine, and poor power pick up. If the catalytic converter has rust holes, the vehicle will also be very loud when running.
Can you drill holes in catalytic converter to help from overheating?
no if theres a hole , it broken . why is it over heating and how do you know its over heating, you cant look at it?
How do you repair a clogged catalytic converter?
You repair a clogged catalytic converter by replacing it. A catalytic converter works by having unburned gasoline or some other substance touch a metallic catalyst such as platinum or rhodium. When the catalytic metal becomes covered over with garbage it stops working. When it stops converting the garbage to carbon dioxide and water, the small holes in it then become clogged. Then it will not let exhaust gasses pass though. No way exists to clean out a catalytic converter. They can only be taken apart and the substance used as raw material to create a new metallic catalyst. You can drive fast and blow the dirt off!
Will a 2004 stock Jeep Grand Cherokee CD player fit a 2000 Jeep grand Jeep Cherokee?
NOT without a custom wire adapter. BestBuy mobile, or eBay The holes for the screws will fit, the wiring is complete different in the 1999-2000 than the 2001-2004 models. But it is possible
How do you tighten the bolts on the torque converter on a 96 grand Cherokee?
Pull the inspection plate off, reach in with an end wrench and tighten them up. Use a screwdriver on the flywheel teeth to turn it so you can get to all of them. If the holes have become elongated, you will need to replace the flex plate.(Flywheel)
Stuff like a beehive with little holes but in the shape of a flake chocolate bar came out of exhaust when i ran it on 1 cylander dumb i know what is it?
sounds like catalytic converter is coming apart.
How do you line up the torque converter to the flywheel?
To line up the torque converter to the flywheel, first, ensure that the torque converter is fully seated into the transmission pump. Then, align the converter's mounting holes with the flywheel's holes, ensuring that the converter is positioned properly so that it engages the engine's flexplate or flywheel correctly. Rotate the engine by hand if necessary to align the bolt holes, and then securely fasten the torque converter to the flywheel with the appropriate bolts. Finally, double-check that the converter is not binding and that it spins freely.
What did Cherokee Indians build there house with?
The Cherokee idians built there houses with wood and hay to cover the holes iv the longhouse.
Will a front bumper from a 2008 Jeep Grand Cherokee fit a 2006 Jeep Grand Cherokee?
Yes I am looking into doing it on mine also. The headlights are a little different they have grooves on the bottom that incorporate into the bumper and the grill is different. You might also have to get the bumper plastic reinforcement piece behind the actual bumper cover. It will line up though to the original holes as long as you get those other parts. Good Luck!
Setting the clock 2005 Jeep Grand Cherokee?
reset clock on 05 cherokee? If unit doesnot have H & M holes, hold in "TIME" button until hour starts to flash, then turn tuner knob to adjust hour. After this, press tuner knob once, minutes will begin to flash, turn tuner knob to adjust minutes.
