How can you disable factory security alarm on 1994 grand jeep Cherokee Laredo?

Answer 1

Deactivating/activating the belt minder feature

Read steps 1 - 9 thoroughly before proceeding with the

deactivation/activation programming procedure.

The Belt Minder feature can be deactivated/activated by performing the

following procedure:

Before following the procedure, make sure that:

² the parking brake is set

² the gearshift is in P (Park) (automatic transmission).

² the ignition switch is in the OFF position

² all vehicle doors are closed

² the driver's safety belt is unbuckled

² the parklamps/headlamps are in OFF position (If vehicle is equipped

with Autolamps, this will not affect the procedure.)

To reduce the risk of injury, do not deactivate/activate the Belt

Minder feature while driving the vehicle.

1. Turn the ignition switch to the RUN (or ON) position. (DO NOT

START THE ENGINE)

2. Wait until the safety belt warning light turns off. (Approximately 1

minute)

² Steps 3--5 must be completed within 60 seconds or the procedure will

have to be repeated.

3. Buckle then unbuckle the safety belt three times, ending with the

safety belt unbuckled. This can be done before or during Belt Minder

warning activation.

4. Turn on the parklamps/headlamps, turn off the parklamps/headlamps.

5. Buckle then unbuckle the safety belt three times, ending with the

safety belt unbuckled.

² After step 5 the safety belt warning light will be turned on for three

seconds.

6. Within seven seconds of the safety belt warning light turning off,

buckle then unbuckle the safety belt.

² This will disable Belt Minder if it is currently enabled, or enable Belt

Minder if it is currently disabled.

7. Confirmation of disabling Belt Minder is provided by flashing the

safety belt warning light four times per second for three seconds.

8. Confirmation of enabling Belt Minder is provided by flashing the safety

belt warning light four times per second for three seconds, followed by

three seconds with the safety belt warning light off, then followed by

flashing the safety belt warning light four times per second for three

seconds again.

9. After receiving confirmation, the deactivation/activation procedure is

complete.

Answer 2

go to the passenger side. remove fuse cover, pull fuse #6. this will disable your auto fuel pump shut off. now you can start your Jeep and go home. however, your VIC may still be flashing if it has gone to flash mode. this is just for shut down mode and won't let you start. and you can drive. the other option is to pull your battery cables and sit for for an hour. so as not to run your battery down. I would not want to short out anything as the previous poster mentioned, and risk having to get a new computer, which I already did once at $500!

Answer 3

Find the power wire to the speaker and cut it. Some factory alsrms have security devices included in them.

disconnect the horn.... then pull the fuse once inside for the hazards

Answer 4

Pull out the fuse for the Factory Alarm, and no more alarm!

where is the fuse

Answer 5

To disable the alarm on a 2002 Ford Explorer, disconnect the battery. Leave it disconnected for around 10 minutes. You can also pull the fuse to the alarm.