Improve the antenna.
Two way radios should be set at the same frequency. Then, 2 or more persons can communicate with each other via those radios, by pressing buttons and speaking.
An analog signal is a continuous signal that contains time-varying quantities. Unlike a digital signal, which has a discrete value at each sampling point, an analog signal has constant fluctuations. netonplus.com
Noise signal is any signal which interferes with the main signal and does not give any important information.Signal should always be twice to that of noise.
In the microphone, there is a diaphragm, which converts the DJ's voice into an electrical signal. This signal is sent along the wire to the antenna, which broadcasts it into the ether. Your home radio receives the signal through its aerial, then converts the signal from an electrical signal to audio - which is detected by your ear.
because demodulated FM is an audio signal, which the frequency is much smaller that is why it can be transmitted alone. It need carrier which has large frequency. Modulated signal is an audio signal + carrier that is why the amplitude is higher.
A Motorola signal booster can be bought at various retailers. One can buy a Motorola signal booster online at websites such as Amazon, eBay, and Signal Booster Store.
transitor
amplifier will strengthen da small input signal n amplifies it
741 opamp
Antenna amplifiers are used to strengthen the signal being supplied to an appliance such as your TV. Amplifiers are necessary when the signal is weak and interferes with your TV reception.
The Motorola Talkabout is a 2-way radio with a range of up to 35 feet and serves as a great tool for hikers, due in part to its emergency signal which can be activated if you are in trouble in the middle of the wilderness.
You have to use a strength booster or so called wireless extender.
You are in range of a radio signal that uses the Evolution-Data Optimised telecommunications standard. http://en.wikipedia.org/wiki/Evdo
In simple terms, when the Page button is pressed on the base unit of a cordless phone, the transmitter circuit within the base is then activated and a signal is transmitted to the portable unit. The portable unit receives the signal and then creates a tone of some sort to alert the user that a Page has been sent.
Carrier signal is of high frequencies, it gives strength to the original signal because original signal cannot travel long distances so it needs to be strengthen a bit for transmitting. The carrier signal is a high frequency signal, called an RF. Radio Frequency signal, it is to high for the human or animal ear to detect it, so its outside the audible spectrum and can easily be transmitted over the air to receivers that is tuned to receive that frequency and detect any modulation on that signal.
Hi My mobile moto X model is not detecting sim card. I couldn't see network signal. What is solution ? Thanks Motorola Service
The official definition for the word amplified is "increase the volume of (sound), especially using an amplifier."