set up of the apparatus is arranged in circuit.ES is the standard e.m.f and Rs is the standard resistance of a cell.K1 is connected to position 1 and K2 closed.The approximation balance length is located.The jockey is tapped along a uniform wire until the G shows no deflection.K2 is then switch on the balance length is located accurately.The length ls is measured and recorded together with the ammeter. The procedure is repeated
When you extend the slide it changes the pich which changes the note
Unlike the rest of the brass family, trombones change notes by moving a slide instead of using valves.
The pitch is changed on a trombone by moving the slide or changing your ombisture.
All brass instruments (except the sousaphone) have slides. They are used to adjust the pitch, sharp of flat. The instrument that is played using a slide is the Trombone. It also has a slide on the back that is used to tune, or adjust pitch.
Sorry you can't, but you can try using a hard kitchen knife to kind of bent the lid to slide your money out.
An ammeter should not be used as a voltmeter. An ammeter is a low impedance device that measures the current going through a circuit, often by measuring the small voltage across a known resistance. A voltmeter is a high impedance device that measures the voltage across a circuit. If you were to connect an ammeter as if it were a voltmeter, you would effectively short out the circuit, drastically affecting its operation, and potentially damaging both the circuit and the ammeter.
An ammeter measures amperage not voltage.
calibrate it .
A potentiometer and a rheostat are two different applications for a variable resistor.A potentiometer is a variable resistor, connected (using its three terminals) as a variable potential divider.A rheostat is a variable resistor, connected (using two of its three terminals) to adjust current.
yas
u mean potentiometer or a metre bridge ? 4 metre bridge R/X=L/(100-L)
By using an Ammeter in series
The disadvantage of using a voltmeter and ammeter on circuit measurements is that internal burden in both these instruments can affect circuit operation so much as to make a measurement useless.
ammeter, which is understood as an amp meter
Electrical current is measured using an ammeter.
Multi-range ammeter using universal shunt
using master vacuum gauge and master pressure gauge