How do you change a front parking lamp on a 1994 Jeep Grand Cherokee?

Answer 1

There are two screws attaching the assembly. The first is at the top just inside the corner edge of the hood area. The other one is located between the gap of the parking lamp and the turn signal. Use a screwdriver with a slender shaft.

Answer 2

On some cars you open the hood,and the light socket will be righton the inside behind the fixture itself. A quarter turn counter clockwise and pull will remove the socket.Then push in while turning a quarter turn counter clockwise again will release the bulb, or on newer ones, you just pull them out as they are the spade type.On some cars you will have screws/torx screws holding the lens assembly in, and it would have Tobe removed to replace the bulb.Then still on others, you wouldreach underneath the bumper.

Answer 3

The brake, turn signal, back-up, and side marker lamps are incorporated in the tail lamp. # Remove the screws attaching the lamp to body . # Disengage the lamp from the alignment pin. # Disconnect lamp wire harness connector. # Separate lamp from vehicle. The brake, turn signal, back-up, and side marker lamp bulbs are incorporated into the tail lamp. # Remove the tail lamp. # Rotate the bulb socket counterclockwise. # Separate the socket from the lamp # Remove the bulb from the socket