answersLogoWhite

0

take your key and turn the lock on the drivers side door, turn till the security light goes off, hold for 3 to 4 seconds I get out of the car, stick the key in either door lock and unlock the door, then it should work. lock all your doors. go to the back lift gate and turn the key. sometimes the lock in the lift gate gets stuck and sets off the security system, exspecially after the battery died or was disconnected. I was just having the same problem after having it towed for 100.00 and two hours of taking apart the dash all it took was to lock the door open the hatch 1st with the key then unlock the drivers door. this worked for me i hope it works for you. I was just having the same problem after having it towed for 100.00 and two hours of taking apart the dash all it took was to lock the door open the hatch 1st with the key then leave it open for a few minutes ,then close it ,then unlock the drivers door. this worked for me i hope it works for you.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you disable anti-theft on a 1991 Misubishu Montaro Sport?

To disable the anti-theft system on a 1991 Mitsubishi Montero Sport, first, locate the vehicle's fuse box and identify the fuse related to the anti-theft system. Remove the fuse to disable the system temporarily. If the vehicle has a factory-installed security system, you may also need to consult the owner's manual for specific instructions. If problems persist, consider contacting a professional mechanic for assistance.


Disable air suspension on 1991 Lincoln continental?

if you need to disable it then go to the trunk and turn off the air system on the left side.


What year Jeep Cherokee computer fits a 1991 Jeep Cherokee?

A 1991 Jeep Cherokee computer is what fits a 1991 Jeep Cherokee.


Location of security module 1991 Jeep Cherokee Limited?

it located under the steering wheel under the dash by the gas pedal.


What are the ratings and certificates for Cherokee - 1991?

Cherokee - 1991 is rated/received certificates of: USA:G


What to do when the security system on a 1991 Jeep Cherokee will not allow jeep to start and key will not turn in lock to reset system?

If the security system on a 1991 Jeep Cherokee will not allow the jeep to start and the key will not turn in the lock, disconnect the battery for a few minutes. Try the key in the lock with the battery disconnected. If it works the first time, reconnect the battery and the system should be reset. If the key does not work in the lock, reconnect the battery and reprogram the key fob.


Will a 1993 Cherokee motor work in a 1991 Cherokee?

Yes


Will parts from a 1991 Cherokee work for a 1999 Cherokee?

Most parts from a 1996 and earlier Cherokees will fit a 1991. The Cherokee changed style and designs in 1997, so few 1999 parts will fit a 1991.


Will a AW4 trans from a 1991 Jeep Cherokee fit a 1988 Jeep Cherokee?

An AW4 transmission from a 1991 Jeep Cherokee will not fit into a 1988 Jeep Cherokee. The transmissions in the varying years do not appear to be compatible with one another.


Will a 1991 4.0 motor fit in a 1989 4.0 jeep Cherokee?

No the 89 uses a renix system which is incompatible with the 91 engine.


How do you reset the security system on a 1991 corvette?

To reset the security system on a 1991 Corvette, first, ensure the driver's door is closed. Insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in this position for about 10 minutes until the security light goes out, then turn the key back to the "Off" position and remove it. After that, try starting the engine; the security system should be reset.


Will a trans from a 1991 Jeep Cherokee fit a 1988 Jeep Cherokee?

The transmission oil line from a 1991 model of a Jeep Cherokee will fit a 1988 model of a Jeep Cherokee because the transmission oil line fits all Cherokee models that were made between 1987 and 1996.