How do you fix the radio display light on a 2001 Nissan Quest or how does the radio get the power for the LED display?

Answer 1

Go to www.shareamemory.com/radio for $19.99 they provide directions. Go here for a free step by step instructions free: http://forums.vmag.com/mvquest1199/messages/363.html For free instructions, go here... http://www.Ford-trucks.com/forums/112400-radio-display.html To recap: 1. Pull out drink holder out and remove two screws. 2. Pry the console out from the top, no need to completely remove. 3. Remove four screws holding the radio. 4. Disconnect 3 wire harnesses and antenna to remove radio. 5. Open radio face plate. 6. Open the top cover of radio. 7. Remove small circuit board inside radio to the left by bending 2 twisted tabs and remove one screw. 7. On bottom of circuit board, look for surface mount components R1057/C1071/R1058/C1083/R1064. 8. Resolder with small tip soldering iron. I resoldered all the joints while I was at it, just to be sure. Total time from getting the tools from the toolbox and clean everything up was less than 1 hour. Good Luck!! Some cases, you will need to replace the board of the CD/cass unit. This is due to a component in the LCD being fried, which can be seen by removing it from the system including the metal plate covering it. The component is in the lower-right corner (facing the display), and is locked within the LCD glass.

Answer 2

you dont. it is self contained within the radio there are no bulbs to replace. radio replacement with a aftermarket radio is a cheaper solution the rediculos cost of a new factory radio or to have a electronics repair place fix the display