How do you remove a neutral safety switch 93 jeep Cherokee?

Answer 1

There is no factory kill sw installed on a cherokee. Therefore normally if one is installed the wires are cut under the steering wheel and that is where it is spliced in usually it is a large diameter wire with several small wires, usually unplugging the small wires and reconnecting the large wire will cure the problem.

Answer 2

On the passengers side of the trans about even with the front of the door fan shaped switch held on by two bolts.

I suggest taking it apart and cleaning it before you think about replacing.

The switch is nearly $300

To remove, flatten out the retaining washer side under nut, remove large nut, remove smaller ( 14mm ) bolt on the adjustment side. Connector for the wires is top left of engine at the firewall, black connector with about 8 wires, you will need to snip 3 or so zip ties to get it free, the switch will slide off the bolt protruding from the trans..

cleaning is easy, 6 screws in back, pull apart, clean out all that old grease, pay special attention to the two contacts on the sweeper arm, they should move in and out easily as they have springs underneath and are the man contacts, apply new di-electric grease and reassemble.

reassemble and align before tightening, easiest way is to put trans selector in R and move switch until reverse lights come on.

Answer 3

necesito ignition switch on jeep Cherokee Laredo 1996 mi correo es skyrouse@hotmail.com

Answer 4

A 2002 Jeep Grand Cherokee does not have a kill switch.