the viscous is located inside the transfer case... you need to pull the transfer case out and split it open. While you are there you might as well throw a fresh chain and bearings into the transfer case as well.
Labor cost lifter for jeep cherokee
4 days
It's your viscous coupler. That part is located in the rear housing of your transfer case. Likely there is nothing wrong with the transfer case itself, these couplers are a wear item and do not last forever. Mine went at 203,000 miles. You can replace the coupler and avoid the cost of a new transfer case. It's possible to replace it with the transfer case still in the jeep, that's how I did mine. Or you can pull the whole unit if that's something you're comfortable with.The replacement procedure isn't difficult but reaching the snap ring can be a bit tricky with the case in the truck.
I'm trying to replace the headlight assembly for a 2000 Jeep Grand Cherokee Lerado. What bolts or screws do I remove
yeah it has one and hope you don't have to replace it
How do I replace water pump on 2004 jeep grand Cherokee
empty the oil out of it then remove the bolts from the nose. i believe there is 13 of them but not sure. then carefully slide it off. remove the coupler. then replace the coupler. line up the holes and reattach the nose. replace the bolts and tighten them down. fill up the supercharger oil.
Jeep grand Cherokees are normally more $ than regular Cherokees, the grand Cherokee was originally made to replace the Cherokee
already have it loose
The Jeep Grand Cherokee didn't exist until 1993.
No, the NV247 transfer case has an oil pump and a clutch pack that does the job of locking in the all wheel drive.
Labor cost lifter for jeep cherokee
yes
4 days
Replace the bulbs
Yep
You have to take it to a bodyshop its easier like that