You disarm it by unlocking either of the front doors with a key. If that doesn't work, that means that the lock cylinder switch has fallen off of the cylinder. You will have to remove the door panel to reinstall/replace.
OR. you could just pop the hood, and diconnect the battery for about a minute
Close all doors, hood and trunk...place key in drivers door and turn it to lock and unlock...some times you have turn it 2-3 times...this should work...worked on my Jeep..hope this helps...
put your key in the rear door or the passenger side open lock, that should stop alarm from sounding crank up and go
if you have a factory alarm..you will need a power remote to reset the alarm. or you can reset the alarm be using the key in any of the door locks or in the rear hatch lock . just cycle the key to the unlock position to shut alarm off. to reset alarm to armed use the door lock power switch to lock the door then shut door and alarm will reset to on .
Try unlocking either the driver's door or the liftgate with the key.
put your key in and turn it forward but not all the way , unplug the battery then hold the pos cable and neg cable together for about 45 sec. then put them back on the battery and turn your key that should disable it ... good luck
the only way we have found to reset the security was too lock the driver door, then using your key, unlock the driver door. repeat as ness. the only way we have found to reset the security was too lock the driver door, then using your key, unlock the driver door. repeat as ness.
You must press 5 second on your remote desalarm
The alarm is reset with the remote or by unlocking the door with the key.The alarm is reset with the remote or by unlocking the door with the key.
The factory alarm is reset with the keyless remote or by unlocking the driver side door with the key. If you have an aftermarket alarm, the reset could be anywhere, but is usually under the dash on the driver side.
Unlock the driver door with the key or use the remote.
The factory alarm is reset with the remote or by unlocking the door with the key.
It can not be disabled, it is reset with the remote or by unlocking the door with the key.It can not be disabled, it is reset with the remote or by unlocking the door with the key.
You unlock the door with the key or with the remote.
if you have a factory alarm..you will need a power remote to reset the alarm. or you can reset the alarm be using the key in any of the door locks or in the rear hatch lock . just cycle the key to the unlock position to shut alarm off. to reset alarm to armed use the door lock power switch to lock the door then shut door and alarm will reset to on .
There is no reset button. The alarm is disarmed by using the remote or turning the key in the door lock.
Unlock the car with the remote or the key in the door.Unlock the car with the remote or the key in the door.
No such button exists. You have to deactivate the alarm with the remote or turn the key in the door.
Had the same problem. You can reset it by unlocking either door with the key.
turn it off with the remote or you must use the key in the door.