You do not reset it, it is a fault code. It is not a routine maintenance indicator. Fix the problem and the light will go out.
Hit the step button until you see 0km to service the hold down the reset button.
Turn the key on. Press step until 0 miles to service is displayed. Press and hold reset.
if your refering to the service computer then its probably time for an oil change to reset it after you change oil hit select then set to reset comp to count down the 3000 mile service schedule.
Press and hold the reset button about 3 seconds.it gonna be appear how many miles you need... it works..
To reset the oil change required light: turn key on, engine off; press gas pedal to the floor three times; cycle key.
Check engine light is reset with a scan tool.Oil change due is reset by pressing "step" until "0 miles to service" is displayed. Then press and hold "reset" until it resets.
AnswerThe answer can be found in your owner's manual.Key on, engine off.Press "step" until "0 miles to service" is displayed. Press and hold "reset".
Key on, doors shut, press "step" until 0 miles to service is displayed, press and hold "reset" until mileage resets.
With the engine turned on and someone in the driver seat. Hit the step button until 0 miles to service appear, hit RESET. A beep will sound and it is done.
Open your owner's manual. Key on, doors closed. Press "step" until "0 miles to service" is displayed. Press and hold "reset" until it resets.
You will need a reset tool to reset the service indicator on the Mercedes e240. You will reset the indicator by using the buttons on the dash.
Key on, close doors. Press "step" until "0 miles to service" is displayed. Press and hold "reset".
Hit the step button until you see 0km to service the hold down the reset button.
Simply turn on your engine, then momentarily press select button display followed by holding down the set button
Press the step button until "0 miles to service" is displayed. Press and hold "reset" until it resets.
Press the step button until zero miles to service is displayed. Press and hold reset.
Start the engine. Then press the C/T button . Then tab the the computers setup with the step button until you see 0 miles to service. After you see that, you just simply press the reset button, and the 0 miles to service, should change to 3,000 miles to service.