To set an alarm on a John Lewis digital radio, first press the "Menu" button and navigate to the "Alarm" settings using the tuning dial. Select "Set Alarm," then choose the desired alarm time and sound. Confirm your settings, and ensure the alarm is activated. Finally, check that the radio is plugged in or has sufficient battery power.
It is fairly easy to set an alarm on a GE cd clock radio 7-4801A. Hold down the alarm button. While doing this, you will want to change the time shown. this will be the time the alarm goes off. Finally, turn the alarm on.
Hold down the wake button while u set the time on the hour and min buttons. Then slide to alarm !!
No, there's not.
because it is set for security purposes ONLY
digital alarm clocks have copper but analog clocks depend on who made it
On the back there should be an alarm set knob (the one with the picture of a bell). On the face of the clock there should be a small, red, short, extra "hand" that doesn't move with the time; that's the alarm setting. Holding the face towards you, turn the alarm knob on the back until the alarm hand points to the time you want the alarm to go off, based on where the hour hand would be (remembering that the hour hand of an analog clock moves slowly between the numbers of this and the next hour, so 6:30 would be halfway between the 6 and the 7). Then there must be a way to turn on/off the alarm. Set this to on before you go to bed at night. In the morning when you wake up you will set this to off to stop the alarm. Don't turn it back on until before you go to bed, or else it will go off at the PM, not the AM, version of the alarm time.
Some were made with alarms but these were not common.
To set the alarm on a WR 50M watch, usually you can press the "Mode" button until you reach the alarm mode. From there, you can press the "Set" button to configure the desired alarm time. Once you have set the alarm time, remember to save the setting and activate the alarm function.
You can set the alarm volume on a sliding scale of one to ten for the Elgin Travel Alarm Clock.
how do you set the alarm on the Timex T434s nature sounds triple alarm clock radio
how do i set the alarm on the lg ally
The Koda iStereo iP915 does not have an alarm. You could probably set the alarm on your iPod.
To set the alarm on your iLuv, first, press the "Alarm" button on the device. Then, use the "+" or "-" buttons to adjust the hour and minutes for the alarm time. Once set, confirm by pressing the "Alarm" button again, and ensure the alarm indicator light is on. Finally, adjust the volume if needed, and your alarm is ready to go!
Set the Alarm for Monday was created on 2008-05-13.
To set the alarm on a Sharp model SPC315, first press the "Alarm" button to enter alarm setting mode. Use the "Hour" and "Minute" buttons to adjust the time for the alarm. Once set, press the "Alarm" button again to confirm the settings. Ensure the alarm is activated by checking that the alarm indicator is displayed on the screen.
How to set alarm and time