Take the radio out. On the back is a red cable and a yellow cable. About 2 inches down are the connectors. undo them and swap them over so that red connects to yellow and yellow connects to red.
to set time turn it off and use select
Never knew that there was a security code for the radio, just set the stations etc.
Guglielmo MarconiWhen Marconi built his first radio it was set to a specific frequency to match the receiver/transmitter that he was going to communicate with...variable tuning came later. The transmission was not voice, but "Click" code.The advent of commercial radio "Stations" and broad use brought about the need for variable tuning.So the FIRST radio would have had one hard frequency setting at a time.
I Don't Know Mabby BUY A NEW CAR!!!!!!!!!!!! I CAN BELIEVE ALL THE IDEOTS IN THE WORLD!!!!!!!!!!!!!!!
To set radio stations on a Mercedes E320, first tune to the desired station using the radio controls. Once you've found the station you want to save, press and hold one of the number buttons (1-10) on the dashboard until you hear a confirmation beep or see a message indicating the station has been stored. Repeat this process for each station you wish to save. You can then easily access these stations by pressing the corresponding number button.
Anytime a battery cable is disconnected you have to reprogram the set radio stations
to set time turn it off and use select
push and hold
My code was 1156 or 1165 I don't know if this will help you
Never knew that there was a security code for the radio, just set the stations etc.
On the factory radio you tune to the channel you want and press and hold the number you want it programmed on (1-6)
To set the radio in a 2010 Jeep Compass, first, turn on the ignition and press the power button on the radio. Use the radio dial or the seek buttons to navigate through stations. You can save your favorite stations by pressing and holding one of the numbered preset buttons until you hear a beep. To adjust the volume, use the volume knob or buttons on the dashboard.
The benefits of WiFi internet radio include the ability to hear radio stations that may be being broadcast from anywhere in the world. Conventional radio relies on radio waves that can be transmitted to a set distance on a set frequency band. WiFi internet radio requires just a stable internet connection.
turn the radio on manually tuner in stations push the set button andnumber for station like 1 2 3 etc.
In most cases Manually tune to the desired station Hold button until display blinks - should be set.
AM stations have a longer radio wave while FM radio waves are only set for a few cities. While you are traveling from Omaha to Chicago, you will probably be able to hear the FM radio until you get to Council Bluffs. If you are listening to AM, you will most likely be able to hear it most of the way there. This is because of the radio waves.
You use the preset station buttons on your radio in the code order, if you have entered it correctly after the last number entered it will set to on mode in approx 5 secs then you set your prefered stations as per normal.