This vehicle has full-time 4wd. There is no option to make it rear-wheel drive.
either behind or in front of the arm of your brake pedal. Follow the brake pedal up until you find a box, either in front of or behind the brake pedal. You will find that the box has a button on it that is activated by your brake pedal, that is the neutral safety switch.
How to change the brake switch on a 2004 Jeep grand Cherokee Laredo
It is not equipped with a fuel switch.
You most likely tripped the NSS =Neutral Safety Switch. I'm guessing you saw a spark while you were messing with your lights. A mechanic can fix this for you.
Yes. Make sure that the transmission is in Neutral and that the transfer case is also in Neutral.
On a 2000 Jeep Grand Cherokee, the neutral safety switch is typically located on the transmission, near the transmission linkage. It is mounted on the side of the transmission case and is connected to the gear shifter. This switch prevents the engine from starting unless the transmission is in the "Park" or "Neutral" positions.
It only allows starting in park and neutral and it turns on the reverse lights.
It is on the valve body inside the transmission.
the neutral safty switch is located in the trans range switch if you have an aw4 auto trans replace or clean and reinstall the switch
find the conector(s) and jump it. also try starting your vehicle in neutral.
this is a GT with floor shift and 3800 engine
It is inside the transmission, on the valve body. It is called a range sensor.
You might want to check your park-neutral safety switch, if it is not engaged the starter will not run.
Trouble code P1899 means: Park/ Neutral switch stuck in park or gear
Usually it is located on the shifter inside the console. You have to disassemle the console around the shifter to get to it.
Problem solved...the culprit was bare neutral switch wires shorting out and blowing the fuse!!!!!
either behind or in front of the arm of your brake pedal. Follow the brake pedal up until you find a box, either in front of or behind the brake pedal. You will find that the box has a button on it that is activated by your brake pedal, that is the neutral safety switch.