remove 2 screws on the side of the dash, in between the door. remove screws holding the dash underneath the steering wheel. It might be 2 or 3, I can't remember completely. Disconnect the plug for the light dimmer. Pull dash panel out.
You must remove the entire dashpad. Remove the fuse panel on the driver's side, there is a screw there. Also remove this panel on the passenger side, screw there too. Then several screws on top holding pad in. Sounds like a lot but not bad.
Better yet. Step by step instructions here. I have to do it also!! http://www.automotiveforums.com/vbulletin/showthread.php?t=321030
1.On both the right and left sides of the black housing that goes around the radio and air controls, there is a circle with another circle inside of it, push in the middle circle, this will release the clips, remove those.
2. the three buttons on top of this piece can be disconnected from it by squeezing the clips underneath.
3. remove plastic shroud.
4. there should be two bolts at the near the top, remove these.
5. slide radio out, disconnect clip, and antennae.
6. done
nostalgiair.com
yeah i wonder mines 2002 Chevy cavalier and it just says "err" yeah i wonder mines 2002 Chevy cavalier and it just says "err"
http://www.installer.com/cars/chevrolet.html
You need to replace the dimmer switch in your gauge cluster. This was caused by a bad ground happens all the time.
There should be a black ground wire in the Chevy Celebrity radio wiring harness. If for whatever reason that is not available then simply hook a wire from the metal shell of the radio to a convenient point on the dashboard near the radio. I would use a convenient bolt or screw if at all possible.
I need to replace the after market radio/cd player in a 2003 Chevy Cavalier. How do I get the existing radio out and install a new one. How do you remove the dash trim without damaging the retainer clips and all the other plastic parts, then install the new after market radio/cd player?
"97 Chevy cavalier" radio diagram which wires go where
no
Remove the cover from your 1986 Chevy Cavalier radio. Remove the radio retaining screws. Slide the radio out and remove the wiring harness and the antenna cable.
i have a '96 cavalier and all u have to do is stick a screw driver in the panel beside the radio to where u can get your fingers in there and just pull it out. but be careful that u dont break the panel or the clips.
the is no code
i have a 1997 chevy cavalier the wipers and radio work when turn the key swich back
you will have to take your dash apart from were the gauges are all the way to the radio
nostalgiair.com
no
www.the12volt.com has free wiring diagrams.
Which model