There are some complex physics behind string vibrations. Essentially, the looser the string, the less nodes, or points where the sound waves go from crest to trough. This of course affects the frequency, or rate at which the string vibrates. So when the string is tightened, more nodes are created, and the frequency increases, increasing the pitch.
Tightening a string makes it sharper, loosening the string makes it flatter. This is used to tune a guitar; the strings should be tightened if they are too low and loosened if they are too high.
It raises the pitch. The higher the tension the higher the resonant frequency and therefore the pitch increases.
A violin produces sound by the vibration of the bow on the string, or the vibration when you pluck a string.
Causes it to give a note of higher frequency
If a violin string is tightened, the volume does not change, the note does. If you tighten a string, it gets higher, and if you loosen it, it gets lower.
The violin is the smallest member of the string family.
well the tighter it is means it is stretching a lot so it make is harder to make noise but if it is quite loose it makes a big loud hard noise cause it is not struggling.
A violin produces sound by the vibration of the bow on the string, or the vibration when you pluck a string.
Causes it to give a note of higher frequency
If a violin string is tightened, the volume does not change, the note does. If you tighten a string, it gets higher, and if you loosen it, it gets lower.
Its main (and only) method of producing sound is the vibration of its strings, thus it belongs in the stringssection.
The pitch of any violin string is changed depending on which spot on the fingerboard a finger is placed.
Sound is a vibration of air molecules, at a frequency we can hear. The air is set into vibration by something else that is vibrating; the vocal chords, the violin string, the drum diaphragm, the falling water, the falling tree.
No. A string half as long as a violin string set vibrating will produce a note one octave higher. That is exactly how the violin is played. When the violinist moves his hand up and down the fingerboard, he is literally shortening the strings making the notes higher or lengthening them to make them lower. The lowest note a violin can reach is the open G string. That is the G below middle C. Pressing down on that string raises the pitch. When you tune your violin, you tune your A string first and then tune your other strings to that string.
The violin is the smallest member of the string family.
well the tighter it is means it is stretching a lot so it make is harder to make noise but if it is quite loose it makes a big loud hard noise cause it is not struggling.
The vibration takes place in the body.
The violin is the smallest member of the string family.
Violin and viola