As many as you want. It is the power consumed by the thing(s) plugged in that is of concern.
No. Receptacle is rated at 15 amps and the wire that feeds it will also rated at 15 amps. Since it will take 20 amps to trip the breaker the wire will be become overloaded. The above is true only if it is a single dedicated outlet. You can use 15A duplex outlets on a 20A circuit, ie: kitchen and dining room outlets per the National Electrical Code.
The only safe way to change your (fuse/breaker) would be to check your wire size and your load size. Fourteen guage wire is rated for a maximum capacity of 15 amps, if your wire size if 12 guage copper then the answer to your question is yes you can change your (fuse/breaker) to a 20amp. You should also call a qualified electrician to install your (fuse/breaker)
From the 1994 Ford Econoline Owners Guide #8 radio memory, 15 amp fuse. #11 radio and clock, 15 amp fuse. #14 power windows, 20 amp circuit breaker.
Normally 15 amp max
Yes, but don't try to put 15 amps through it! You might need to change your plug too!
Use a 15 amp breaker and 14 AWG wire and all switches and outlets rated at 15 amps or greater.
A 30 amp breaker is usually used for a dedicated 30 amp device. Ordinary 15 amp receptacles can not be connected to a breaker of higher trip capacity than the rating of the receptacle. The wire size for a 30 amp breaker is #10 AWG.
There is no limit as to the amount of circuits you can have in a garage. If you mean how many devices on a 15 amp single circuit breaker then the answer is 12. Be sure to total in light fixture outlets and switch boxes.
Technically, they can be on a 15 amp breaker when you use 15 amp outlets. There is a difference. Be sure to check your local code (just call the city building department and tell them you have a code question). some cities require the bedroom outlets to be on an arc-fault breaker.
No more than ten. If you used a 20-A breaker it would be up to 13.
It's the amps that are controlled by the breaker not the volts. You can have a 600 volt 15 amp breaker, you can have a 347 volt 15 amp breaker. The breaker will trip when you exceed 15 AMPS.
Replace the 30 Amp Breaker with a 15 Amp breaker.
On a 20 amp circuit, it is safe to install up to 13 outlets that are rated for 15 amps each.
A 15 amp breaker is not sufficient for a 225 amp load. You would need a breaker that matches the load current, such as a 225 amp breaker. Using a 15 amp breaker for a 225 amp load would cause the breaker to trip immediately due to overcurrent.
No, the six outlets are not amperage rated to be connected to a 20 amp circuit. A normal 15 amp receptacle can not be protected by a 20 amp breaker. Change the 20 amp breaker to a 15 amp breaker. This combination will pass code regulations. =============== In the United States, in a home, you can connect two hard-wired (not cord and plug connected) fans and six receptacles (outlets) to a single 20 amp circuit provided the 2 fans do not draw more than 10 amps together. If they are cord and plug connected, this limitation on the fans does not apply. In commercial and industrial installations, power to hard-wired equipment is provided on different circuits than receptacles.
No, you should not replace a 15 amp breaker with a 20 amp breaker without consulting a licensed electrician. The breaker size should match the wire size to prevent overheating and potential fire hazards.
The maximum current rating for a 15 amp circuit breaker is 15 amps.