You will have to get a new neck.
NEVER adjust the truss rod in order to lower the strings. The majority of string height adjustment is done at the bridge on either the bridge posts or individual saddles depending on your guitar. The truss rod is only there to correct any humping or bowing in the neck, if you tighten it then the strings will appear to lower but that's only because you're bending your guitars neck back! This will render your guitar pretty much unplayable until it's sorted so if you're not completely confident you know what you're doing then it's best to just leave any truss rod adjustment well alone. If you value your guitar then seek the advice of a qualified or experienced luthier or repair guy.
No, they do not require a truss rod. Some of the Banjoleles have them installed, but they aren't required.
No. Some less expensive guitars do not have truss rods in their necks. Any guitar that is more than a toy should have a truss rod, with out the truss rod if your guitar got into some moisture and the neck bowed,you would not be able to straighten the neck out.
You can't!
In short you can do, but it's a very lengthly process and will cost you a fair bit of cash. Usually the way to do it (assuming your neck is deep enough to accommodate the truss rod) is to remove the fretboard, then route a channel down the centre of the neck under the board, install the rod with the adjustment nut at the headstock end, then reglue the fretboard. Though TRUSS me, it's a lot harder than I made it sound just then! I'd recommend taking it to your local repair place to get a quote and don't try it yourself unless you're a master router. If the problem you're trying to fix with a truss rod is that you're guitar neck is slightly warped, then a slightly easier option would be to get the frets out, plane/sand the fretboard level and then get it re-fretted.
Yes there were truss bridges in Europe before the United States. Truss bridges formed in the US because of Europeans, but new American designs were made and that is why the truss bridge is more abundant in the US than Europe today.
As far as i can tell there are 27 different types of truss bridges (i.e. Brown truss, Bowstring truss, Kingpost truss, Long truss, and Pratt truss). Hope this helps :D
a truss
the truss
trussesWarren truss bridge
NEVER adjust the truss rod in order to lower the strings. The majority of string height adjustment is done at the bridge on either the bridge posts or individual saddles depending on your guitar. The truss rod is only there to correct any humping or bowing in the neck, if you tighten it then the strings will appear to lower but that's only because you're bending your guitars neck back! This will render your guitar pretty much unplayable until it's sorted so if you're not completely confident you know what you're doing then it's best to just leave any truss rod adjustment well alone. If you value your guitar then seek the advice of a qualified or experienced luthier or repair guy.
It is light weight but it is strong because of the open.
In a plane truss, both the truss structure and the applied loads lie in the same plane.In a space truss, either the structure or the loads or both lie in different planes.
In plane truss, both the truss structure and the applied loads lie in the same plane. In space truss, either the structure or the loads or both lie in different planes.
I want to build a truss bridge because truss bridge is most economical and his dead load is too low.
No. A truss bridge is composed of trusses
Yes