Haynes says that the torque specs for the rocker arms is 19 ft/lbs, and is the same for both the 2.5 I-4 and the 4.0 I-6.
Beneath their coils.
They are under the coils.They are under the coils.
Yes.
At the top of the engine. The intake needs to be removed to access the plugs on the drivers side. Since there are no spark plug wires, the coil packs need to be removed. The plugs can then be removed and replaced with new ones. See the link below for detailed instructions.
No. The spark plugs are all in line (assuming you've got a v6). There are a few bolts to the left of the block, take them out, disconnect the electrical harness and pull.
Dirty spark plugs can occur on any make, model, or year. Changing the spark plugs should be done for maintenance, such as when you do a tune up.
How to replace spark plugs in a 1989 jeep cherokee?
Beneath their coils.
Torque the spark plugs to 11 lb/ft.
They are under the coils, next to the fuel injectors.
test the temp sensor. Check spark plugs,plug wires,torque convertor. test the temp sensor. Check spark plugs,plug wires,torque convertor.
it is a diagram of the engine?
They are under the coils.They are under the coils.
Cheap ones run for $2. Premium Bosch plugs run for about $6 a piece.
Open the bonnet and you'll see them (With leads attached to them ) on top of the engine block.
I dont know the torque for the 2000 but a rule of thumb is, with ratchet get the plug snug and go a quarter turn. allways use anti-siez lube for plugs on your plugs.
Yes.