OC goes to COIL- G goes to ground IB goes to ECU
Marcato
The Renaissance is the age of great change marked by renewed interest in classical learning and the arts.
red curb or a no parking sign
Epiphone guitar headstock marked used because it did not pass inspection serial number replaced with used mark to void any warrenty claim
$50
Positive terminals typically have a red color or a "+" sign indicated, while negative terminals are usually black or have a "-" sign marked. Additionally, positive terminals are connected to the cathode, while negative terminals are connected to the anode in a battery or electrical device.
On the battery is marked - or +. The red cable is positive and the black is negative.
Terminal represents or are ends in a Electrical Circuit that connects components in Circuit to the Power Source. Terminals are either Positive or Negative marked at the ends denoting the acceptible floe of electrons across the Circuit.
To wire an AC disconnect, first turn off the power to the unit. Connect the hot wires to the terminals marked "Line" and the neutral wires to the terminals marked "Load." Make sure to follow the manufacturer's instructions and local electrical codes. Finally, secure the wires with wire nuts and close the disconnect box.
Some capacitors have terminals as they are polarized but some have not as they are not polarized. you can easily identify a polarized capacitor as it has + or - terminal indication marked.
To disconnect the battery in a Seat Leon FR, first ensure the vehicle is turned off and remove the key from the ignition. Locate the battery in the engine compartment, typically on the driver's side. Use a wrench to loosen the negative terminal (marked with a minus sign) and remove it first to prevent any electrical short. Then, repeat the process for the positive terminal (marked with a plus sign), ensuring both terminals are safely disconnected.
CAM or Spark? the cam has cogs, they are marked. the disty is not marked, (like all disty) but needs IGnition strobe light ($20 at HF)
Check fuse panel inside cab and under hood for relay/fuse box, one of these should have terminals, studs, marked just for this purpose, with the new computer controled cars/trucks you dont want to tap into wires.
If it's a Prius you have to take the black cover off of the fuse case. The terminals are well marked, ground the black wire and go!
Jump pins marked "D" and "F" for code retrieval.
Two, and possibly a ground. The ground will be clearly marked with a green colored screw.
Its under the back passenger seat. There are remote jump start terminals under the hood marked with a red cover on the left side facing the car.